OSQ 0-303 Portable DVD Projector User Manual

OSQ 0-303 Portable DVD Projector User Manual

FCC WARNING STATEMENT

FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
3. The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning:
The device has been evaluated to meet general RF exposure requirements.

RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

PACKING LIST

NOTICE

FUNCTION OVERVIEW

REMOTE CONTROL

BATTERIES STATEMENT AND NOTICES

Remove the battery compartment cover on the back of your remote by carefully sliding to open. The battery cover can then be lifted away. Fit the correct batteries, referring to the polarity markings. Finally, replace the cover.

NOTE:

• When you receive the product and find that the batteries of the remote control is swollen or softened, please do not use it before you change it.
• Batteries shall not be exposed to excessive heat such as sunshine, fire.
• Make sure that the batteries are installed polarity correctly.
• Only same or equivalent type batteries as recommend are to be used.
• Do not dispose of batteries in fire, battery may explode or leak. Do not try to recharge a battery.
• Do not mix old and new batteries.
• Do not mix alkaline, standard(carbon-zinc), or rechargeable (ni-cad,ni-mh,etc) batteries.

QUICK START

PROJECTION DISTANCE & SIZE

The recommended projection screen is around 80 inches with a distance of around 9.7 ft. Ambient darkness will improve the clarity of the projected images.

PROJECTION MODE

If you want to hang the projector to the ceiling, a projector mount will be needed.
If you want to project in different way, please select corresponding mode in the setting page.

INPUT SOURCE

C. DVD Player Connection
Supports direct play of CD, DVD, CD-R/RW, DVD -R/+ R, DVD+ RW/-RW, VCD, SVCD

Note:
1. Not support Blu-ray disc.
2. The DVD button on controller only works in the main interface.
3. Please through Source button to exit DVD interface.

BLUETOOTH SETTING

Bluetooth Connecting

NOTE:

1. Bluetooth function is ONLY for audio transfer with audio devices, like Bluetooth speaker/headset/sound bar, NOT support video/audio sync with smartphone/Pad.
2. Due to compatibility issues with the Bluetooth protocol, some brands of Bluetooth speakers may not support connection to OSQ projectors.
3. Control the Bluetooth switch by the left/ right buttons on controller

WIFI CONNECTION & SCREEN MIRRORING

WIFI CONNECTION

SCREEN MIRRORING

MIRACAST (For Android System)

NOTE:
Please remember to turn on the WiFi function on your Android device, but not necessary to connect to any WiFi signal.

iOS CAST (For iOS System)

DLNA (For Android and iOS Device)

NOTE:
1. The DLNA connection can be operated in any page of the projector.
2. Through the DLNA connection, the mobile phone can continue to be used normally, and the projected video/image will continue to be played, but the mobile phone interface will not be displayed synchronously.

DIGITAL ZOOM

NOTE:
Digital Zoom could be set on this interface or through MENU button on controller.

SPECIFICATION

TROUBLE SHOOTING

WARRANTY

OSQ provides the following service for each customer:

• 30-days full refund or free replacement
• 1-year technology support
• Lifetime professional consult

If you need any help or want to extend the warranty time for your order, please email us: m us-projector-303@eitack.com

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>