RadiantLight 27 tall Address Marker Landscape Light Garden Light Instruction Manual
- June 2, 2024
- RadiantLight
Table of Contents
**RadiantLight 27 tall Address Marker Landscape Light Garden Light Instruction Manual
**
INSTALLATION INSTRUCTION
-
You will get 4 stakes, 4 locking screws, 1 TedStuff tightening wrench, to attach landscape spikes to fixture. This will turn your Deck Mounted light into a landscape spike mounted light so you can
-
install it in the Earth.
-
Position stake as pictured and line up holes.
-
Install locking screw.
-
Use wrench provided to tighten locking screw.
-
Attached the 2 wires from RadianLight the to your new or existing 12 to 15 volt low voltage lighting systym wire.
-
Bury the wire and position in place. You can push down into place from the topper. Be careful to push down the sides over the mounting screws so the cover will net bend – or buy gripping the sides of the light to push down.
-
Level in place.
-
Fill in the soil, mulch, or rocks, etc. and enjoy.
-
Locate where you want to install your Lights.
-
Mark feet holes with marker, don’t forget to mark the hole for the low voltage wire to connect to the Lamp.
-
Drill 4 holes in the Deck for the feet attachemt and one for landscape connection wire.
-
Attach the 2 wires from the Radiant Light to your new, or existing 12 to 15 volt, low voltage light system wire.
-
Attach to Deck, depending on your serface, wood, concrete, pavers etc. Any Hardware Store can direct you to the proper fastener type.
-
ENJOY!!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>