SVB Conversion Kit for Marine Toilets Instruction Manual
- June 2, 2024
- SVB
Table of Contents
SVB Conversion Kit for Marine Toilets
Dimension
VERY IMPORTANT
Wire size per foot and meter of run
Cleaning
- Regular flushing with clean (water represents one of the most effective methods to keep the toilet clean and good smelling.
- To clean the bowl, use any liquid or cream ceramic cleaner
- To clean the rest of the toilet, including the seat and lid, use a non-abrasive liquid cleaner Polish with a dry cloth only to disinfect the toilet, use a liquid disinfectant diluted by the manufacturer’s instructions.
- It is possible to apply it to all parts of the toilet using a sponge or soft brush as necessary.
- After applying any cleaning or disinfecting agent, always flush well. DO NOT ALLOW THESE AGENTS TO STAND IN THE SYSTEM.
Warranty
Products are guaranteed two years. No warranty will be recognized in the
following cases: if the bowl is broken if the fitted instructions regarding
the electrical system and the directions for use have not been properly
followed Warning: the use of strong detergents to clean the toilet is
forbidden, as these products stay on the inside of the system and burn the
pump rubber seals through. Eventual traces found in the claimed goods
will invalidate the warranty.
CAUTION: Safety advice:
WARNING: FLOOD HAZARD If the toilet is installed below the waterline, or
maybe below the water level at any moment beach may cause oss I property and
lie cAd woh never post the Volt de ce ve alise ou de seien, result and fang
ing, of potable water contamination. If freshwater is preferred for flushing
the bowl, provide a separate freshwater tank to supply water to the toilet
only.
- Electric toilets can be installed above or below the sea level.
- Maximum sell-priming height is 1.2 m Maximum discharge height is 1.2 m.
Toilet above the waterline
- 19 mm. sea-cock 2. Inlet non-return valve 3. 20 cm.
- Rise above the base to retain water in the toilet bowl 4. 38 mm. sea-cock
Toilet below the waterline
- 25 mm. or 38 mm. sea-cock
- At least 20 cm.
- 25 mm. or 38 mm. vented loop
- 19 mm. sea-cock
- 19 mm. vented loop complete of solenoid valve
- Heeled waterline