zinici B0CJNS58FT Portable Photo Booth Instruction Manual

zinici B0CJNS58FT Portable Photo Booth

Package List

Details of various screws

• 5pcs

• 8pcs

• 4pcs

• 4pcs

• 15pcs (On the panel)

RGB fill light introduction

Easy Installation Instructions

Bracket mounting

1. Remove all the accessories
   

2. Take out the(3)support rod and(5)base and align them with the holes
   

3. Lock the four screws of the base using the hex screws and hex wrench as shown in the picture
   

4. Take the(4) support rod, use the key to open the newly installed back cover, expose the hole as shown in the picture, align and insert
   

5. Use the hex screw and hex wrench as shown in the picture to lock the 3 positions as shown in the picture. Make sure not to miss them
   

6. Find the line as shown in the picture from the support rod below, insert it through the hole between the two rods, and align the connector with the connector
   

7. Find the RGB fill light line in the lower support rod, thread through the just-threaded port, and pull the line tight
   

8. Find the controller as shown in the picture in the support bar below, there is a two-dimensional code on it, download the APP or you can consult us
   

9. Insert the thread from the upper part of the two holes, no difference
   
   Fill light installation

10. Remove the hand screw on the upper back cover of the RGB fill light, f as shown
    

11. Remove the manual screws and remove the strips of the pressing plate
    

12. Select the corresponding panel and press screen bar. There are two panels to choose from. Please select the one you need
    

13. Put in the corresponding iPad, put the strip pressing the plate into it, and lock it with manual screws
    

14. Put in the back plate that was removed before and lock it with hand screws as shown in the picture
    

15. Use the protruding support, notch aligned with the upper part of the stop bolt, use M3 cross screws to lock
    
    Integral installation

16. Use the (2)support rod and M4 phillips screws to align the four holes in the upper part of the support, and tighten them using a screwdriver
    

17. There is also a screw hole in front of the support rod, which needs to be fixed with M4 Phillips screws
    

18. Lock the adjusting support bar to the upright bar just installed using spin screws and hex socket screws
    

19. Tighten M4 hexagon socket screws and spin screws as shown in the figure, Use a hex wrench to lock the positioning screws
    

20. Put the thread perforated in the light box through the hole supported by the back cover and insert it into the switch of the fill light
    

21. Overall effect display
    

Operating Instructions for Photo Booth

Note: Before using the product, please read the instructions carefully! Do not attempt to disassemble the product. If the product is not working properly, please contact our partners.thank you!.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>