Hoglet RF-107 Wireless Mouse User Manual
- June 2, 2024
- Hoglet
Table of Contents
Hoglet RF-107 Wireless Mouse
Specifications
- Data transmission: 1 Mbps
- Frequency: 2405 MHz – 2476 MHz
- Channel: 16
- Engine: Optical
- Voltage: 1.5 V
- Current: 11 mA
- Mouse Key Life: >3 Million Clicks
- Tracking Resolution: 1600 DPI
- Polling Rate: 250 Hz
- System Requirement: workable USB port
Product Usage Instructions
1. Installing Batteries and USB Receiver
- Remove the battery cover.
- Install the batteries (1 AAA) in the battery box.
- Install the USB receiver in the computer’s USB port.
2. Turning On the Mouse
- Remove the USB receiver.
- Turn the mouse on using the power switch located next to the right button.
3. Basic Troubleshooting Steps
- If the mouse is unresponsive, try the following steps:
- Replace the batteries with new ones and ensure proper installation.
- Disconnect and reconnect the USB receiver to establish a new connection.
- Move the mouse closer to the USB receiver.
- Toggle the on/off power switch.
FAQ
- Q: How do I know if my wireless mouse is connected?
- A: When the mouse is successfully connected, the cursor on your screen will move as you move the mouse.
- Q: What should I do if my mouse stops working suddenly?
- A: Try replacing the batteries first. If the issue persists, contact customer support for further assistance.
Overview
- A Left button
- C Scroll wheel & middle button
- Ê USB receiver
- B Right button
- D Power switch
- F Battery box
- Remove the battery cover
- Install the batteries
- Remove the USB receiver
- Install the USB receiver in the computer USB port
- Turn the mouse on
Basic Data Parameters
- Data transmission: 1 Mbps
- Frequency: 2405 MHz – 2476 MHz
- Channel: 16
- Engine: Optical
- Voltage: 1.5 V
- Current: 11 mA
- Mouse Key Life: >3 Million Clicks
- Tracking Resolution: 1600 DPI
- Polling Rate: 250 Hz
- System Requirement: workable USB port
Trouble Shooting
If the Hoglet is unresponsive, try the following steps:
- Replace the current batteries with new batteries and ensure proper installation
- Disconnect and reconnect the nano receiver to the USB port to establish a new connection to the mouse
- Move the mouse closer to the USB receiver
- Toggle the on/off power switch
- Contact us at [email protected] your problem persists
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
HedgeHogHealth.com@hedgehoghealth