Trust ZPIR-8000 Motion Detector User Manual
- June 2, 2024
- Trust
Table of Contents
Trust ZPIR-8000 Motion Detector
COMPATIBILITY
The sensor works with the Z1 ZigBee Bridge and the ICS-2000/Smart Bridge.
(RE)PLACE THE BATTERIES
- Remove the battery cover from the sensor.
- Place 2x AAA batteries (not included) in the sensor. Note the positive and negative polarity in the compartment. Close the battery cover.
INDICATORS
The sensor contains an LED indicator (This is not a button) to show the status of the sensor. Please see below the meaning of the different LED indications.
LED FUNCTION TABLE
Connection mode| LED will flash once per second for approximately 1 min.
(After 1 min the LED will stop flashing)
---|---
Connected successfully| LED will stop flashing (The App will also indicate
when the connection is successful)
Sensor reset| LED will flash fast (for 2 seconds)
Sensor triggered (When motion is detected)| LED will flash once
DOWNLOAD APP
- www.trust.com/zigbee
- To connect the sensor with a Z1 ZigBee bridge or ICS-2000/Smart Bridge, first, get the App by scanning the QR code or go to trust.com/zigbee and install it.
CONNECT SENSOR
- In the App, select a room, press the + button, and follow the instructions. For manual setup of push notifications go to the rules tab, press the + button and select notification wizard.
MOUNT THE SENSOR
- Mount the arm of the sensor on a flat surface and secure it with the included screws.
- Place the sensor on the mounting arm.
- Secure the sensor by pulling it down on the mounting arm.
RESET THE SENSOR AND ACTIVATE THE CONNECT MODE
- Warning: This step will remove the sensor from the Z1 ZigBee Bridge or the ICS-2000/Smart Bridge. To reset the sensor press the button in the hole at the side of the sensor for approximately 5 sec with the included pin. The LED will flash fast to confirm the reset.
- Activate connect mode: After resetting the sensor you can activate the connect mode by pressing the button for approx. 1 sec. The LED will flash for 1 minute to indicate the connection mode.
- www.trust.com
References
- Trust.com - Contact & Support - Compliance
- Trust.com - Contact & Support - Installation of ZigBee products
- Trust.com - Home
- Trust.com - Home
- Trust.com - Zigbee Wireless Motion Sensor ZPIR-8000
- Trust.com - Contact & Support - Compliance
- Trust.com - Contact & Support - Safety information
- Trust.com - Contact & Support - Warranty conditions
- Trust.com - Contact & Support - Installation of ZigBee products
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>