PAIQIAN 0331 4 Pieces Patio Chairs with Table Outdoor Bistro Conversation Sets Instruction Manual

OUTDOOR 4 PCS CONVERSATION SET
ASSEMBLY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

• Prior to assembly, make sure you lay out and identify all the parts listed below in the parts list.
• Tighten all nuts and bolts securely. All bolts should be hand tightened before use. Never use power tools or excessive force during assembly and tightening of bolts. ofhw888888@163.com
• Should you experience any difficulty during assembly or if any part is missing or damaged:
  Contact our customer service by email:

Warning:

1. Make sure the conversation set is on a solid, level surfac

Part List

SINGER CHAIR (DO THIS TWICE)

1. Fst put legs (Part A) together by connecting bar (Part D) using bolt N, washer Q.
   Then affix the other two connect bars (Part G) to legs (Part A) seperately by using bolt N, washer Q.

2. Put on single seat (Part B) on legs (Part A) using bolt 0, washer Q, plastic washer P, and nut as shown in diagram.
   
   Attention:
   1. Plastic washer (Part P) must be put between Part A and Part B.
   2. Leave other side loose.

3. Affix supporting bar (Part F) under seat (Part B) as shown in diagram.

4. Attach other side of seat (Part B) to leg (Part A) using bolt 0, plastic washer P, washer Q and nut as shown in diagram.
   Attention: Washer (Part P) must be put between Leg (Part A) and Seat (Part B).

5. At the end of the process, tighten all nuts and bolts securely before use.

LOVESEAT

1. First, Set up legs (Part A) by connecting bar (Part E) using bolt N, washer Q. Then attach back frame (Part H) to legs (Part A) using bolt N, washer Q as shown in diagram.
   

2. Affix the double seat (Part C) to back frame (Part H) using bolt M, washer Q and nut as shown in diagrtam
   

3. Affix the double seat (Part C) to conneting bar (Part E) using bolt M, Washer Q and Nut as shown in diagram.

4. Insert surpporting bar (Part F) to double seat (Part C) as shown in diagram.
   

5. Attach double seat (Part C) to legs (Part A) using bolt 0, washer Q, plastic washer P and nut as shown in diagram.
   

6. In the end, tighten all nuts and bolt securely before use.

COFFEE TABLE

1. Attach table legs (Part J) to the table top frame (Part I) using bolt L, washer Q as shown in diagram.
   

2. Put glass Part K on the Part I as shown in diagram.
   

3. At the end of the process, tighten all nuts and bolts securely before use.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>