LDARC V64 Scale RC Racing Van User Manual
- May 15, 2024
- LDARC
Table of Contents
LDARC V64 Scale RC Racing Van
Product Specifications
- Length: 500mm
- Width: 100mm
- Model Number: 231204 V64
Product Usage Instructions
Safety Guidelines
Do not use or store the product in extreme temperature or humidity conditions.
Avoid running in areas with vehicular traffic or near children to prevent
collisions. Do not operate the product on sand, water, or dusty surfaces to
prevent damage. Avoid driving towards people or animals to prevent accidents.
Maintenance
- Avoid hitting hard objects while driving to prevent damage.
- Consider adding fences around the driving area to prevent damage in case of falls.
- If the low voltage alarm activates (front and rear lights flash quickly), turn off the power promptly to prevent battery damage.
- Before each use, inspect and clean the wheels, chassis, and gear gaps for any foreign objects.
- If storing for an extended period, maintain the battery voltage at 3.8V and perform charging/discharging cycles every 3 months.
Product Notes
The diagrams and descriptions in the manual are for reference only. Actual
products may have slight differences due to updates and upgrades. Always refer
to the actual product for accurate information.
Frequently Asked Questions (FAQ)
Q: How do I charge the transmitter?
A: The transmitter features a built-in 18650 battery that can be charged
via USB-C. When charging, the indicator light is red and turns off when fully
charged. Avoid overvoltage (above 5V) during charging to prevent damage to the
transmitter.
Q: How do I bind the vehicle to the transmitter?
A: To bind the vehicle:
- Press the key and power on the vehicle until the green/blue LED fast blinks, indicating bind mode.
- Select the appropriate mode on the transmitter menu corresponding to the vehicle’s mode. The vehicle will show slow blinking lights after a successful bind.
- Exit the bind menu on the transmitter and power cycle the vehicle.
Safety notice
- The model is not toy, please read the manual carefully before use.
- This product contains small parts. Children under the age of 14 are strictly prohibited from using it to avoid the risk of suffocation caused by accidental ingestion; children over the age of 14 must use it in the presence of a guardian, and do not leave the guardian’s line of sight to avoid accidents
- Adults must be present when charging; please place it out of the reach of children when charging and storing.
- The moving parts are dangerous. It is forbidden to put fingers, hair, clothes and other items into the gap between the tire and the car body, so as not to be stuck by the rotating parts.
- Due to functional requirements, this product contains sharp parts, please operate according to the correct steps and usage methods, and pay special attention to eye safety.
- Please do not bend, throw or use this product in other violent ways to avoid damage to the product or cause an accidents.
- This product has a built-in battery, please do not put it into water or fire (such as stove, gas stove, etc.), to avoid explosion.
- Any accidents such as injury to others or damage to items caused by operating errors are the responsibility of the operator, and the company will not be responsible.
Scenario warning
- Do not use and store this product in high temperature, low temperature, high humidity and other environments.
- Do not running in places where cars are driving or near children to avoid dangers such as collisions.
- Do not running on sand, water or dusty places to avoid to cause product failure
- Do not running it on the bed, the wheels are entangled and cannot rotate, continuous refueling will cause damage to the vehicle.
- Do not drive towards people or animals to avoid accidents.
- Do not throw for the vehicle, as the model car may be damaged if dropped from high place.
Maintenance
- Hitting hard objects while driving may cause damage.
- It is recommended to add fences around the site to prevent damage when the product falls.
- In low voltage alarm state, the front and rear lights flash quickly, please turn off the power in time to prevent battery damage.
- Before each use, please check and clean the wheels, chassis, and foreign objects in the gear gap.|
- When storing for a long time, keep the battery voltage at 3.8V, and charge and discharge once every 3 months.
Note
- The products, accessories, Transmitter etc. in the manual are schematic diagrams and are for reference only.
- Due to product updates and upgrades, there may be slight differences between the actual product and the schematic diagram, please refer to the actual product.
- LDARC reserves the right of final interpretation of relevant regulations.
Package
TX fuction description
Charging
The Transmitter has a built-in 18650 battery, which can be charged through
USB-C. The indicator light is red when charging, and the indicator light turns
off when it is fully charged; please do not charge with overvoltage (5V),
otherwise the transmitter will be damaged.
Driving and steering
Fine-tuning
- Throttle fine-tuning: After the vehicle is powered on, if the vehicle move forward or backward by itself,you can solve it by adjust TH trim.
- Direction fine-tuning: The vehicle cannot drive straight, you can adjust the ST steering fine-tuning.
Light/Function Key
Screen
Voltage compensation calibration
If the actual vehicle’s voltage value measured (multimeter) is inconsistent
with the vehicle return voltage value displayed on the transmitter,
calibration and compensation settings can be made in the transmitter settings:
select “Setting” in transmitter — ” Model Setting”, –” Telemetry” —” LV
Setting” .
Forward and reverse
During use, if you find that the throttle or direction is reversed,you need to
reverse the channel in the transmitter menu.
Transmitter bidirectional data feedback
- The bidirectional data feedbback is an auxiliary prompt and it is for reference only.
- If a connection reminder (out-of-control alarm) appears on transmitter, and the screen shows “no connection” . The car may not necessarily be out of control. It may be because the feedback signal is interfered, the car can be controlled normally. It is recommended to turn off the connection reminder.
- When multiple car are operating in the same venue at the same time, if there is serious mutual interference,please binding again with telemetry off.
Vehicle fuction description
Bind
-
Press the <BIND»key and power on the vehicel, until green blue LED fast blink meaning vehicle in bind mode.
-
Select the
or <Bind TLM-Off» option on the transmitter «Setting>, ‹Advanced> menu, respectively to the vehicel’s < TELEMETRY ON> Or mode. vehicel will red blue slow blink or red
green slow blink after bind success. -
User need exit transmitter from bind menu and cycle vehicle power.
Charging
The indicator light is red when charging, and fully chgarged is green,
charging allowable input voltage is 5V, overvoltage charging will damage the
vehicle.
Power Switch
Vehicle low voltage alarm protection
The vehicle could’t continue and the headlights were flashing red fast.
Light status indication
Vehicle automatically turns off power
If the transmitter is disconnected from the vehicle or the transmitterl is
turned off, the vehicle lights will flash red slowly, and the vehicle will
automatically turn off the power after 60 seconds.
The vehicle low-voltage status alarms, the vehicle lights flash red quickly
and cannot continue driving, and the vehicle automatically turns off the power
after 15 seconds.
Daily car maintenance
- If the wheel is found to be loose, apply an appropriate amount of glue when reinstalling it.
- Clean foreign matter in the hanging area.
- Replace the Vehicle’s shell [unscrew the bottom screws (Picture 1) and remove the car shell (Picture 2 & Picture 3)].
Troubleshooting
Inspection report
Transmitter test
- Press key test
- Channel test
- Charging test
- Distance test
- Led
- Appearance
Vehicle test
- Charging test
- Light
- Distance test
- Driving test
- Appearance
Thank you for purchasing, Enjoy vehicle use time !
Campany information
WWW.LDARC.COM
Manufacturer: DongGuan LDARC Technology Co.,Ltd
Address: JinTianDa Logistics Park, N0.180-140 DongShen Rd,YanTian, FengGang,
DongGuan, GuangDong, China
Email: BOSS@LDARC.COM
Made In China
More manual
LDARC.YSEPAN.COM
Manual/Firmware
Email: BOSS@LDARC.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>