LDARC X43 RTR Remote Control Car User Manual

LDARC X43 RTR Remote Control Car

Safety precautions

1. This model is not a toy, please read the manual before use.
2. Please clean the gear before use.
3. If you use it on the bed, the wheel is wound and can’t be rotated, continuous refueling will lead to damage to the car.
4. Ensure that someone is present when charging. If the device is not used for a long time, keep the battery voltage at 3.7V for storage.
5. Please don’t use it in an environment of water, hair, and dust.
6. The model may be broken when it falls from 8cm and above.

The servo, Motor, and Battery are wearing parts:
Please check within 24 hours of receiving the goods; if you find any problems with the product, please contact the dealer in time.

1. Hitting hard objects while driving will cause damage to the servo.
2. Suggested to add sponge fence around the site to avoid damage to the servos due to it falling off.
3. When wheels are entangled and cannot rotate, and continuous refueling will cause damage to the car.
4. The front and rear lights will flash quickly in a low-voltage alarm state, please turn off the power in time to prevent the battery from feeding.

Overview

CT01 Transmitter

X43 Car

Using Instructions

Charging: The indicator light is red when charging, and changed green until fully charged. charging allowable input voltage is 5V, Overvoltage charging will damage the car.

• The car and TX were bound when RT delivered, please use it directly.
• BNR needs to buy a separate 0› CTO1 TX. The bind method is as follows:

1. Please hang the wheels of the car in the air.
2. Power on the car then press the key within 10 seconds until green blue LED fast blinks meaning the car is in bind mode.
3. Select the or < Bind TLM-Off> option on the transmitter ‹ Setting>, < Advanced> menu, respectively to the car’s or mode. the car will red-blue slow-blink or red-green slow-blink after binding success.
4. User need to to exit the transmitter from the bind menu and cycle car power.

Trim: If the car cannot drive in a straight line, you can adjust the ST trim bullion.

• After the car is powered on, if you find that the car is moving toward or backward, you can adjust the TH trim button.
• Forward and reverse: if you find that the throttle or direction is reversed during use, you need to reverse the channel through the transmitter menu.

Thank you for purchasing, Enjoy car use time!

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF warning for Mobile devices
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Please scan code for more details

• Email: BOSS@LDARC.COM.
• LDARC.YSEPAN.COM.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>