ALLONE GLF-US-01 Smart Lithium Electric Lawn Mower User Manual

ALLONE GLF-US-01 Smart Lithium Electric Lawn Mower

Product Description

Lithium electric lawn mower parts list

①Serrated blade

②Diamond blade

③Gasket

④Backing Plate Screw

⑤Handle

⑥Battery

⑦Charger

⑧Glove

⑨Wrench

⑩Fender

⑪Goggles

Installation Notes

①: Take out the fuselage and install the grass baffle.

Remove the screws of the grass guard, and insert the g rass guard into the machine head corresponding to the groove.

Tighten the screws to secure the fender.

②: Remove the backing plate screw that holds the blade in place.

③: Placing spacers and blades.

Pay attention to the front and back when placing the gasket, and do not shake it after placing it.

3

When placing the blade, the ‘up’ faces you and the gear is counterclockwise.

WARNING: Please pay attention to the direction of the blade. If the blade is installed reversely, the blade will not cut smoothly.

④: Screw on the backing plate screw. Please pay attention to the installation direction of the back plate screws.

⑤: Use a wrench to fix the screw on the shaft, and then use a special wrench to tighten the screw.

WARNING: Be sure to lock the screw securely to hold the blade in place to prevent the blade from falling out during use.

⑥: To install the handle，remove the handle screw.
Fix the handle on the pole，adjust the position and tighten the screw.

When removing the handle screw, pay attention to the screw shown on the left, do not lose it.

⑦: Adjust the motor and install the battery.

⑧: Start using.Adjust to the right length, then press and hold the safety lock and power switch to get started.

!WARNING: When starting to use, pay attention to the position of the motor to prevent injury to yourself and others.

Function Description

①:Gear Adjustment. Click the gear adjustment button.

S Gear: Minimum speed

M Gear: Medium speed

F Gear: Maximum speed

WARNING: It is not recommended to be used as a professional tree cutting tool, and cannot replace the electric chain saw,hand saw and other professional cutting tools.

②: Charging Display.

Red Light:Charging.
Green Light:Fully Charged.
Click the gear adjustment button.
Fully Charged 2-3 hours.

Please use the charger included with the product.
Using a different power charger may cause damage to the battery.

WARNING: Please store the lithium battery in a dry place after fully charging! If the product is not used for a long time, please do a charging cycle every three months. To prevent the battery from being unable to charge normally after power loss.

③: Cut with a blade.

Tip: Do not use the blade in a digging manner.

Tip: If you are trying to cut grass taller than 10 cm or more at a time, use caution by trimming overgrown grass several times from the top of the lawn to prevent the grass from tangling.

Tip: If you find that the cutter head is involved in the turf during use, please turn off the machine in time and clean it up. After use, clean with a dry cloth, and use a brush to clean hard-to-reach places, especially the motor vents. It is strictly forbidden to wash with water.

WARNING: The sundries in the mowing area should be cleared before use, such as stones, steel pipes, toys and other hard objects.

WARNING: This product is intended for household use. D uring use, please keep the working head of the product parallel to the ground, and do not touch the ground, otherwise it will be dangerous.

FQA

①: Question:Sawtooth blade cutting to baffle.
Reasons: Sawtooth blade incorrectly installed.
Solution: Check blade installation status.

②: Question:Difficult to remove battery.

Reasons: Wrong removal method.
Solution: Refer to the steps below to remove the battery.

Step 1: Hold the machine.
Step 2: Press the battery button.
Step 3: Push the battery out.

③:Question: The machine stops suddenly after being used for a long time.
Reasons: The motor vent is blocked causing the machine to overheat or overload.
Solution: Clean the vents, wait for half an hour, the machine can be used again after it cools down.

④: Question:Lithium battery cannot be charged or discharged in winter.
Reasons: The temperature of the lithium battery dropped to minus 5 degrees due to weather, which led to the automatic protection of the battery.
Solution: Put the battery in a warm room and let the battery temperature reach above 15 ℃, and the battery will recover its performance. (Do not use direct heating methods such as fire baking)

Three Gears Adjustable
Power Display

Customer service support

Use Amazon APP to scan QR code or send email to customer service email to contact us.

Technical Support Email: grolf.sz@outlook.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>