SoModren CH0771832BG LED Chandelier Brushed Gold Instruction Manual

SoModren CH0771832BG LED Chandelier Brushed Gold

LED Chandelier

START FROM HERE

• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference

Please Note:

• This LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
• For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
• 120V input

INSTALLATION INSTRUCTION

1. Remove the fixture from its original packaging. Remove the mounting crossbar (1d) from within the canopy (2a) by removing the decorative nuts (2b). Secure the mounting crossbar (1d) to the junction box (1a) with the screws (1g) provided in the hardware package.
2. Install all of the bubble acrylic (3b) to the pendant hub (3a) by threading in clockwise until it is safe and secured. (See Illustration 1 for glass color coding)
3. To remove some of the rods (2d), disconnect the wires from the DC Driver located inside the canopy (2a). Remove the driver cover and unscrew to loosen the wires from the terminal block. Push the wires toward the driver from the connector (2c) and remove the rods of your choice. Remove the driver to have enough space for a wire connection. Connect the wires back to the same connection. Black to positive and White to negative (See Illustration 2 and refer to the diagram on the Driver). Reinstall back the driver to the same position as before. Connect the rods (2d) by threading clockwise starting from the hub (3a) up to the top. Attach the rod (2d) with the fixture to the swivel connector (2c) by threading in clockwise.
4. Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package. Align the holes in the canopy (2a) to the screws (1c) pointing down from the mounting crossbar (1d). Push the canopy up towards the ceiling and use the decorative nuts (2b) to secure the canopy onto the mounting crossbar.

19054 28TH AVENUE SURREY – BC V3Z 6M3 CANADA

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>