NEWTOPTEK TECHNOLOGY XSW-3-045 Bluetooth Remote Control User Manual
- May 15, 2024
- NEWTOPTEK TECHNOLOGY
Table of Contents
NEWTOPTEK TECHNOLOGY
XSW-3-045 Bluetooth Remote Control
User Manual
XSW-3-045 Bluetooth Remote Control
Hold down the “Back” and “Home” keys
of the remote control for 3 seconds at the same time, the remote control list
pairing information, enter the pairing mode, and the red light flashes during
the pairing process. The pairing distance is 20 cm to 1.5 m. If the pairing
is successful, the red light of the remote control will be on for 3 seconds;
If the pairing fails after 30 seconds, press “Put Back” and “Home” to pair
again Device name: ‘RC-27’
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>