Panasonic CONNECT PT-FZ570 LCD Projector User Guide

May 15, 2024
Panasonic CONNECT

**Panasonic CONNECT PT-FZ570 LCD Projector User Guide

**

INSTALLATION INSTRUCTION

LCD, 4500 lumens, WUXGA, Digital Link, 10000:1; long lamp and fitler replacement cycle


PT-FZ570

Price priority and easy installation LCD projector Designed to easily replace current projection installation in education and corporate environments.

Key Features

  • LCD, 4500 lumens, WUXGA
  • Long lamp replacement cycle of 8,000 hours and filter replacement cycle of 16,000 hours.
  • Dust resistant design for lasting brightness
  • 1.8x zoom lens and wide horizontal and vertical lens shiftfor flexible installation
  • 10,000:1 contrast ratio

Power Supply:   AC100 – 240V 4.7 – 1.9A 50Hz/60Hz
Power Consumption;    413W
Power Consumption | Standby Mode (Eco): 0.5W, 0.3W (Taiwan)
Power Consumption | Standby Mode (Normal) :    12W
Power Consumption | Standby Mode (Normal and Audio Monitor Out): 30W
BTU Value: Max 1,410 BTU
LCD Panel | Panel Size: 16.3 mm (0.64 in) diagonal (16:10 aspect ratio)
LCD Panel | Display Method: Transparent LCD panel (x 3, R/G/B)
LCD Panel | Drive Method: Active matrix
LCD Panel | Pixels: 2,304,000 (1,920 x 1,200) x 3, total of 6,912,000 pixels
Lens: Manual zoom (throw ratio 1.22-2.26:1), Manual focus, F 1.6-2.2, f 17.1-31.7 mm

Lamp:

  • 270 W UHM lamp
  • Lamp replacement cycle
  • 6,000 hours (lamp power: Normal), 8,000 hours (lamp power: Eco)
  • This is the maximum value when the lamp is turned on for 2 hours
  • and off for 0.25 hours

Screen Size: 1.02- 7.62 m (40-300 inches) (16:10 aspect ratio)

Brightness: 4,500 lumens
(Lamp power: Normal, Dynamic mode, Iris off, Daylight View:off, Auto Power Save:off)

Center-to-Corner Uniformity: 90%

Contrast: 10,000:1
(Lamp power: Normal, Dynamic mode, Iris on, Daylight View:off, Auto Power Save:off)

Resolution:   1,920 x 1,200 pixels
Scanning Frequency:  | HDMI/DIGITAL
LINK
fH: 15- 91kHz, fV: 24 – 100Hz, dot clock: 25 – 162 MHz
Scanning Frequency | RGB fH:    15- 91kHz, fV: 24 – 100Hz, dot clock: 162 MHz or lower

Scanning Frequency | YPBPR (YCBCR)

  • 525i (480i): fH15.73 kHz; fV59.94 Hz,
  • 625i (576i): fH15.63 kHz; fV50 Hz,
  • 525p (480p): fH31.47 kHz; fV60 Hz,
  • 625p (576p): fH31.25 kHz; fV50 Hz,
  • 750 (720)/60p: fH45.00 kHz; fV60 Hz,
  • 750 (720)/50p: fH37.50 kHz; fV50 Hz,
  • 1125 (1080)/60i: fH33.75 kHz; fV60 Hz,
  • 1125 (1080)/50i: fH28.13 kHz; fV50 Hz,
  • 1125 (1080)/25p: fH28.13 kHz; fV25 Hz,
  • 1125 (1080)/24p: fH27.00 kHz; fV24 Hz,
  • 1125 (1080)/24sF: fH27.00 kHz; fV48 Hz,
  • 1125 (1080)/30p: fH33.75 kHz; fV30 Hz,
  • 1125 (1080)/60p: fH67.50 kHz; fV60 Hz,
  • 1125 (1080)/50p: fH56.25 kHz; fV50 Hz

Scanning Frequency | Video/S-Video fH:

  • 15.75 kHz, fV: 59.94 Hz [NTSC/NTSC4.43
  • fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]

Keystone Correction Range: Vertical ±25°, horizontal ±30°
Optical Axis Shift: Vertical: ±60% (Manual) Horizontal: ±30% (Manual)
Installation: Ceiling/floor, front/rear
Speaker: 4.0 cm (1-9/16 in) 10W (monaural) x 1

Terminals | HDMI In 1/HDMI In 2 | HDMI 19-Pin x2

  • Deep Color, compatible with HDCP,
  • Audio signal: linear PCM
  • (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz)

Terminals | Computer 1 In: D-sub HD 15-pin (female) x 1

Terminals | Computer 1 In | R, G, B :      0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G)
HD/VD, SYNC:         TTL, high impedance, positive/negative automatic

Terminals | Computer 1 In | Y, PB, PR (Y, CB, CR) Y:    1.0 Vp-p (including sync signal),
PBPR(CBCR):       0.7 Vp-p, 75 ohms
Terminals | Computer 1 In | Y/C Y:    1.0 Vp-p (including sync signal), C: 0.286 Vp-p, 75 ohms
Terminals | Computer 2 In/1 Out: D-sub HD 15-pin (female) x 1

Terminals | Computer 2 In/1 Out | R, G, B

  • 0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G)
  • HD/VD, SYNC: TTL, high impedance, positive/negative
  • automatic
  • NOTE: SYNC/HD and VD terminals do not accept tri-level sync signals.

Terminals | Computer 2 In/1 Out | Y, PB, PR (Y, CB, CR)

  • Y:1.0 Vp-p (including sync signal),
  • P BPR(CBCR): 0.7 Vp-p, 75 ohms

Terminals | Video In :   Pin jack x 1, 1.0 Vp-p, 75 ohms
Terminals | Audio In: 1/Audio In 2 M3 x 2, 0.5 Vrms, input impedance: 22 kilohms or more

Terminals | Audio In 3 :   Pin jack(L, R) x 1, 0.5 Vrms, input impedance: 22 kilohms or more

Terminals | Variable Audio Out :

  • M3 x 1 (monitor out, stereo)
  • 0-2.0 Vrms, variable, output impedance: 2.2 kilohms or less

Terminals | Serial In:

  • D-sub 9 p x 1, for external control (RS-232C compliant)

Terminals | DIGITAL LINK/LAN:

  • RJ-45 x 1 (HDBaseT™ compatible), 100Base-TX, PJLink™(Class 1),
  • Deep Color, compatible with HDCP
  • A udio signal: linear PCM (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz)

Terminals | LAN

  • RJ-45 x 1 for network connection 10Base-T/100Base-TX,
  • compatible with Art-Net, PJLink™(Class 1)

Terminals | Wireless: USB Type A x 1, for wireless projection with optional dongle (ET-WML100)
Terminals | DC Out :  USB Type A x 1, for power supply (DC5 V, max 900 mA)
Power Cord Length:   2.0 m (6 ft7 in)
Cabinet Materials; Molded plastic
Dimensions: (W x H x D) 498 x 1453 x 398.3mm
(19-19/32 x 5-11/16
3 x 15-11/16 in ) with supplied lens
Weight Approx; . 7.9kg (17.4lbs)
Operating Noise:     29 dB (Eco), 33 dB (Normal)
Operating Environment | Operating Temperature:    0-40 °C (32-104 °F)
Operating Environment | Operating Humidity: 0%-80% (no condensatio
Technology:    LCD

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Panasonic CONNECT User Manuals

Related Manuals