Libro PLAF109 Polar Wet Food Feeder User Manual

Libro PLAF109 Polar Wet Food Feeder

Please read this manual before using the product and keep it for future reference.

IN THE BOX

1. 1 x Automatic Pet Feeder

2. 1 x Power Adapter

3. 1 x Quick Start Guide

4. 1 x User Manual

PRODUCT OVERVIEW

1. Body

2. Top Lid

3. Rotating Food Section Lid

4. Temperature Sensor

5. Food Bowl

6. Top Lid Release Button

7. Status Indicator
   

8. Cooling Vent

9. Power Port

10. Reset Button

11. Battery Compartment (Batteries not included)
    

Button

Top Lid Release Button| Press to open the top lid

Reset Button| Press and hold for three seconds to reset the feeder

Indicator status

GETTING STARTED

Power on

1. Place the feeder on a level surface, and ensure that neither the left nor right cooling vents are obstructed by foreign objects.

2. Plug in the power cable, and the status indicator will flash white.

App control

1. Scan the QR code or search in your device ‘s app store to download and install the PETLIBRO app.
   |
   ---|---
   
2. Follow the instructions to configure the network.
   

Note:
• This feeder only supports 2.4GHz networks.

Set up the feeder

Scan the QR code to watch a video on how to use the feeder.

1. Press the top lid release button to open the top lid o f the feeder.
   

2. Take out the food bowl and add an appropriate amount of wet food to it.

Notes:

  * Do not exceed the maximum food level line.
  * For hot food, allow it to cool to room temperature before adding it to the feeder.

3. Put the food bowl back into the feeder.

Note: Hold lightly to prevent liquid spills from wet food inside the feeder.

4. Set the feeding time for each added wet food meal in the app and close the top lid.

Note: The time that can be set for a single wet food meal cannot exceed 72 hours (3 days).

5. When the scheduled feeding time arrives, the rotating food section lid will open and automatically close after the pet finishes eating.

Note: Feeding time can be customized within the app.

Backup battery

1. The bottom of the feeder is reserved for a battery compartment. You can choose to install three AA batteries.

Note: Batteries are not included.

2. The backup batteries only work during a power failure; the refrigeration function will stop, but the feed ing schedule with in 12 hours will proceed as usual.

Power off

1. When not in use for an extended period, unplug the power cable to turn off the feeder.
   

Note: Remove backup batteries if they are installed.

CARE AND MAINTENANCE

Scan the OR code to watch a video on how to clean the feeder.

Feeding zone cleaning
Use a dry towel to wipe and clean the feeding zone.

Food bowl cleaning

1. End all feeding schedules of the feeder and remove the food bowl.

2. Clean the food bowl with water and wipe it dry.
   

Refrigeration zone cleaning

Use a dry towel to wipe and clean the refrigeration zone.

Note: Condensation on the bottom of the feeder is normal, and it occurs due to the refrigeration process.

Rotating food section lid cleaning

1. Release the latch to remove the rotating food section lid.
   

2. Clean the food section lid with water and wipe it dry
   

3. Use a clean towel to clean the gap between the rotating food section lid and the top lid.
   

SPECIFICATIONS

Output: DC 12V SA
Number Of Meals| 3
Wireless Frequency| 2.4GHz
Supported System| Android, iOS
Dimensions Power adapter not included)| 361 x 340 x 196mm / 14.2 X 13,4 X 7.7in
Weight (Power adapter not included)| 3.4kg/7.5Ib

SAFETY INSTRUCTIONS

•  Do not use the feeder at temperatures below 0°( (32°F)or above 30°C (86°F).
• Do not obstruct the feeder’s cooling vents.
• Use the feeder in a dry place.
• Use the feeder on a level surface.
• Dispose of all packaging materials properly. Some items may be packed in plastic bags; these bags could cause suffocation.
• Do not use the feeder with pets that are not able to reach the food bowl or with any physical disability.
• Do not immerse the base part in water at any time as it may damage electronic components.
• Do not use the feeder outdoors. Check its operation frequently to be su re it is operating properly.
• Do not disassemble the feeder other than as instructed in this user manual.
• Only use accessories recommended or sold by the manufacturer. The use of accessories not recommended or sold by the manufacturer may cause an unsafe condition.
• Do not modify the feeder.
• Examine the feeder after installation. Do not plug in if there is water on the power cable or plug.
• To avoid tripping, always position the power cable out of the way of foot traffic.
• Power off the feeder when it’s not in use.

WARRANTY

• 12-month warranty
• For guidance on product use, please contact our customer service team via email: support@petlibro.com.

NOTICE

FCC statement

This d evice complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1.  this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modificat ions to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in are sidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does causeharmfu l interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Product Model: PLAF109 PMN: Polar Wet Food Feeder

ISED Statement:

• English: This device complies with Industry Canada license – exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

The digital apparatus complies with Canadian CAN ICES – 3 (B)/NMB – 3(B).

CUSTOMER SUPPORT

www.petlibro.com

@Libro Corp. All Rights Reserved.
Manufacturer: Shenzhen Li bro Technology Co., Ltd.
Address: 12/F, Tower B, GALAXY WORLD, Yabao Road,
Longgang District, Shenzhen, China.
Made in China
CAN ICES-3(8)/NMB-3(8) IC: 28987-PLAF109 FCC : 2A3DE-PLAF109
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
POLAR
Wet Food Feeder

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>