80036734 Solar LED lamp User Manual
- May 15, 2024
- Solar
Table of Contents
User Manual
Solar LED lampe
80036734
IMPORTANT - BEFORE START!
Make sure to check that all items are intact before usage.
Content
1 x Solar LED light.
1 x Remote control.
1 x Plastic stake.
1 x User manual.
Specifications
| Material | PE plastic |
|---|---|
| IP klassification | IP68 water resistant |
| Colors | RGB colors+ white. |
| Batterity | Li-Ion battery (built-in, non-replaceable) |
| Remote distance | 4 meters |
| Charging time | A full day with sunlight |
| Working time | 4-8 hours |
| RGB-colors working time | 8 hours |
| Solar panel | 0.5 W |
Functions
- The solar LED lamp can light up in a single color, but you also have the option of switching t one of the other colors.
- The solar LED lamp is charged via sunlight.
Safety instructions
The built-in rechargeable battery cannot be replaced. .
NEVER try to open the light switch cover.
Always make sure to unplug the device when not in use.
If the product is broken or otherwise damaged, the device must not be used.
Please contact dealer if this is the case.
Make sure to keep the LED speaker away from flames, fire and chemicals.
The battery must not be removed or replaced; if it is to be disposed of it must NOT be thrown in the trash. It must be acquired according to the measures for disposal of batteries. If you are in doubt, how and where to dispose the battery, refer to the regulations set out by the government for the disposal of batteries
Operation
During the day, the solar panel converts the sunlight into electricity, which thereby recharges the battery.
If you would like to check the light during the day, please take the product into a dark room or hold your hand above the solar panel. The reason why this is recommended is, that at night the solar panel will automatically light up when charged.
If the product is placed in the shade, the battery will not be fully charged. This will therefore reduce the lighting time for the solar LED lamp.
The chosen location of the solar LED lamp should not be near another night light source, such as porch light, streetlight, or pool light, as this may cause the sunlight to flicker or turn off prematurely.
The first time the solar LED lamp is used.
- Start by carefully removing all the packaging.
- Place the lamp in a place where it receives a full 8 hours of sunlight to give the lamp the best conditions to shine for as long as possible.
- To ensure that the lamp is stable, you can insert the supplied stake into the bottom of the lamp and then, carefully, stick it into the ground.
- For the first 24 hours, it is recommended that you make sure that the light is kept OFF, in order to fully charge it.
To turn the lamp on or off, then press the ON/OFF button.
When the lamp is set to OFF , it inters the so-called POWER NAP MODE.
When it is in this mode, it continues to charge but does not light up.
To change the color, you must use the supplied remote control.
Storage and maintenance
Always make sure to turn off the OFF button when the unit is not in use.
Make sure that the LED speaker is not stored too cold (below 0 degrees) nor too hot, as this can have an impact on the product’s functionality and lifespan.
If the LED speaker is to be stored for a long time, the temperature must be between 0-25 degrees.
ATTENTION! If the LED speaker is stored for more than 3 months without being used, it must be charged before being used again.
MORELAND A/S
KNULLEN 22
5260 ODENSE S
Documents / Resources
|
SOLAR 80036734 Solar LED
lamp
[pdf] User Manual
80036734 Solar LED lamp, 80036734, Solar LED lamp, LED lamp, lamp
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>