pulox PS-100 Simple Pedometer Instruction Manual

: May 15, 2024
: Pulox

Table of Contents

FIRST STEPS / FIRST TIME USE
FUNCTION
INCORRECT STEP COUNT
CHANGE BATTERY
SPECIFICATIONS:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

pedometer – Instruction manual

PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE USE

pulox PS 100 Simple Pedometer -

FIRST STEPS / FIRST TIME USE

Pull the battery insulator/insert the battery into the battery compartment to activate the pedometer.
If the LCD display shows unusual characters or the screen freezes and/or no steps are counted, please perform a system reboot. See section: PERFORM REBOOT.
When you insert a new battery, the LCD display may show faint background digits. This is normal with a new battery. These will disappear when the battery drops to its normal operating voltage.

FUNCTION

LCD-Display
Hanger for lanyard
RESET button
Battery cover

STEP COUNTER FUNCTION
The 3D accelerometer counts steps in any position, no matter how you wear it- even in your shirt pocket. The pedometer starts counting as soon as motion is detected.
10 STEPS ERROR CORRECTION
To prevent unintentional movements from being counted as steps, the pedometer only starts counting after ten steps have been detected.

INCORRECT STEP COUNT

The pedometer may not count correctly under the following conditions:

Irregular movements like swinging and vibrating
Uneven walking speed

RESETTING THE PEDOMETER
To reset the digits of the pedometer to “0”, simply press the RESET button on the back of the device until the display shows the digit 0.

pulox PS 100 Simple Pedometer - figer1

CHANGE BATTERY

The pedometer uses 1 piece CR2032 button cell battery.

Unscrew the battery compartment with a coin.
Remove the old button cell battery and replace it with a new one. Make sure that the battery is inserted correctly and observe the polarity.
Screw the battery compartment tightly shut again.

PERFORM REBOOT
Perform a system reboot in the following situations:

When you replace the battery (if necessary)
When the LCD digits become unrecognizable or dark.
If nothing happens after pressing the button

Remove the battery from the device. This resets the pedometer to the default setting.
The current data on the LCD display is deleted and reset to “0”.

SPECIFICATIONS:

Battery: 1 piece CR-2032
Pedometer: up to 99,999 steps

Dispose of the device in accordance with the Waste Electrical and Electronic Equipment Regulation 2002/96/EC: WEEE (“Waste Electrical and Electronic Equipment”). If you have any queries, please contact the local authority responsible for disposal. The used, completely discharged batteries and rechargeable batteries are to be disposed of via the specially marked collection containers, special waste collection points or via the electrical dealer. You are required by law to dispose of the batteries and accumulators appropriately. WEEE No.: DE24355330

Novidion GmbH
Fuggerstr. 30 • 51149 Cologne • GermanyTel.: +49 (0) 2203 / 9885 200
Fax: +49 (0) 2203 / 9885 206
www.pulox.de • Mail: info@novidion.de