BATTERY MATE M832 Blue Compatible Garage Door Remote Control Prolift Instructions
- May 15, 2024
- Battery Mate
Table of Contents
BATTERY MATE M832 Blue Compatible Garage Door Remote Control Prolift
Product Information
Specifications
- Type: Roller Door Opener and Receiver
- Compatibility: Works with various roller doors and receivers
- Power Source: Electrical
- Range: Up to 100 meters
- Features: Remote control operation
Product Usage Instructions
Roller Door Opener
- Ensure the roller door opener is correctly installed and powered.
- Pair the remote control with the opener following the manufacturer’s instructions.
- To open or close the roller door, press the corresponding buttons on the remote control.
- Regularly check the batteries in the remote control for optimal performance.
Receiver
- Install the receiver in a suitable location within range of the remote control.
- Pair the receiver with the remote control by following the provided pairing instructions.
- Test the receiver by sending signals from the remote control to ensure proper functioning.
- Keep the receiver away from interference sources for uninterrupted operation.
FAQ
- Q: How do I reset the roller door opener?
- A: To reset the roller door opener, locate the reset button on the device and hold it for 10 seconds until you hear a beep.
- Q: Can I program multiple remote controls to operate the roller door opener?
- A: Yes, most roller door openers support programming multiple remote controls. Refer to the user manual for specific instructions.
On overhead door openers
- With five exposed terminal screws at the rear
- Remove the small black cover to the right of the terminal screws
- Learn is the RED button under the black cover
- Learn is the RED button under the black cover:
- Learn is the RED button under the black cover.
- Find the small button marked “Learn”
- With four covered terminal screws at the rear, and a Merlin wired wall switch
- The small button on the Merlin wall switch is the Learn button
On roller door openers
- A single small square RED button on the front.
- Remove the lamp cover; remove the small black cover to the left of the lamp holder
- The learn button is the RED button under the black cover
- Large RED or GREEN push switch on the front
- Remove the RED or GREEN control panel cover
- Find the small button marked “Learn” Large RED or GREEN push switch on the front and a Merlin wired wall switch
- The small button on the Merlin wall switch is the Learn button
On other receivers
- Dark grey boxed receiver with a large round GREEN button
- The Learn button is the small DARK GREY button inside the GREEN button
- Gate receiver cards: The Learn button is the tact switch on the PCB marked “Learn”
- Others: See your receiver’s user guide, or inspect and find a button marked “Learn”
PROGRAMMING THE NEW REMOTE TO THE OPENER OR RECEIVER
- Press and hold the Learn button for 1 to 2 seconds.
- Press the desired button on the remote control which you want to operate the door twice.
Programming the remote to control the lamp on your opener (if fitted)
- Press the desired button for the secondary function.
- Press and hold the Learn button for 1-2 seconds.
- Press the desired remote control button once for the main function (open door).
- Press the desired remote control button once for the secondary function (control lamp)
WARNING!
This product may contain a coin/button cell battery. Keep products and
batteries away from children. Battery can cause severe or fatal injuries in 2
hours or less if swallowed or placed inside any part of the body. Seek
immediate medical attention if it is suspected that a coin/button battery has
been swallowed or placed inside any part of the body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>