BATTERY MATE M2000 Compatible Garage Door Remote Control Instructions

BATTERY MATE M2000 Compatible Garage Door Remote Control Instructions

Duplicator Coding Instructions

1. Press and hold the top two buttons at the same time and do not let go (these will either be an unlock/lock symbol, numbers 1 & 2 or an up and down arrow). After a few seconds the LED will flash and then go
2. While still holding the first button (lock, UP or button 1) release the second button (unlock, down or number 2) and then press it 3 The LED light will flash again to indicate that the factory code has successfully beendeleted.
3. Release all
4. Test the remote by pressing a button on the remote. If the deletion of the factory code has been successful, the LED should not work when you press any button.

STEP 2: Copying the Code from an Existing Operational Remote

1. Place both your new remote and original remote You may need to try different positions, head to head, back to back etc.
2. Press and hold one button on your new remote you wish to operate your The LED will flash quickly and then go out to indicate that your duplicator remote is in the “learn-code” mode. Do not release this button.
3. Press and hold the button that operates your door on your original remote – this will send out the signal for your new remote to learn. When you see the LED light on your new remote start flashing constantly – then coding has been.
4. Release all the buttons, and then test your new remote to make sure that it is

How to Restore an Accidently Erased Remote Control:

1. Press and hold the bottom
2. buttons on your new remote for 5 seconds

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>