IHAYNER A16 Wireless Pager System User Manual
- May 15, 2024
- IHAYNER
Table of Contents
Quick Start -Wireless
Paging System A16
Check the items in the pack
| Part | QTY |
|---|---|
| Transmitter (aka Charging Base/Host) | 1 |
| Receiver (aka Pager) with Protection Film/Advertising Paper | 18 |
| Power Adapter of Transmitter | 1 |
Tech Specifications
| Transmitter | Receiver |
|---|---|
| Size | 23515836 mm |
| Material | ABS |
| Power | 100 mW |
| Frequency | 315 MHz |
| Range | 1000m (open area) |
| Power | DC/9V 1A |
| Max pager Qty | 98 |
| Code | Learning code |
| Keys life | 1 million |
| Waterproof | No |
| Receiver Slot Qty | 16 |
Common Operations
A. Power On/Off
- Power On – Connect to the power adapter of Charing Base, the pagers will auto power on.
- Power Off – Put the pagers on the charging base when charging, then enter “99” on the keyboard, and press the “call” button, the pager will auto power off.
Reminder : Please turn off the pagers during closing time to avoid affecting battery life.
B. Set the beep/vibrate/Flash length
With the pager turned on, take off the advertising paper, then press the
yellow metal button.
One reminder light represents the beep/vibrate/flash time of 8 seconds. The
time is increased by 8 seconds every time you press the button shortly. And a
maximum, of 5 lights on, the time can be increased to 40 seconds.
C. Turn off the beep (keep quiet but turn on vibrate/flash)
With the pager turned on, take off the advertising paper. Then shortly press
the yellow metal button a few times until the lights are all off.
D. Number Programming
When the charging base and the pagers are charging and turned on, take off the
advertising paper on the pager which you want to add and press the yellow
metal button on the pager.
When the two lights on the right side are on, enter your number on the
keyboard and press the “CALL” button within 5 seconds, the pager number will
change and be done. Please mark the new number on the pager.
Attention : all pagers in the pack have been done the programming
operation before shipping. This operation only occurs when a replacement pager
needs to add.
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received. including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions. may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception. which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Need help? Email or WhatsApp us!
SAVE OUR EARTH, PRINT ON BOTH SIDES.
Email: Support@apominton.com
WhatsApp: +852 6817 5723
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>