Criss Cross C-7262 Office Chair Instruction Manual
- May 15, 2024
- Criss Cross
Table of Contents
Criss Cross C-7262 Office Chair Instruction Manual
Safety Information
To deodorize the leather leave the chair in a shady outside for 1-2 days.
For longer use
Re-tighten bolts every 6 months by using the enclosed allen-key.
*Using an electric drill can damage the chair. Please re-tighten bolts manually.
-
Sit in the center of the chair, with your back to the backrest
-
Do not sit at the front edge of the chair
-
Do not stand on the chair
-
Do not use the chair with more than one person
-
Do not push the chair around when a person is sitting in it
-
Do not push down on the backrest when a person is reclined
-
Do not place all your weight on only the backers
Package List
-
(A) *1 Backrest
-
(B) *1 Seat Cushion
-
(C) *1 Mechanism
-
(D) *1 Gas Lift
-
(E) *1 Base
-
(F) *4 Bolts
-
(G) *4Bolts
-
(H) *5 Leg
-
(I) *5 Caster
-
(J) *5 Foot Pad
-
(K) *5Bolts
-
(L) *1 Wrench
Assembly Instruction
Remove the cover from Base E and use Wrench L 1 and Bolt K 5 to 1 connect
Base E to leg H * 5.
Press and install the Caster I 5 or Foot pad J 5 onto the Leg H * 5, 2 and then place the Cover and Air Rod D onto Base E.
NOTE:
The Mechanical C and the Seat Cushion are labeled “FRONT” in the same
direction.
Connect Mechanism C and Seat Cushion B with Wrench L 1 and 3 Bolt F 4.
Align the screw holes on the Seat Cushion B and Backrest A. 4 Using Wrench H,
secure both completely with Bolts G*
Align the hole on Mechanism (C) with Gas Lift (D), and press 5 the Chair down
until it is fully secured.
Instructions For Use
CAUTION:
- Before using the chair, check to ensure that all bolts are fully tightened.
- Lubricate all parts and tighten all bolts every 6 months or whenever needed.