PROCELL Retrofit Insite Retrofit Module User Guide
- May 15, 2024
- PROCELL
Table of Contents
QUICK-START GUIDE
Retrofit Insite Retrofit Module
Ensure floor and room are assigned to the location before beginning the install process.
ADDITIONAL RESOURCES
PROCELL® InSite
Quick-Start Video
STEP 1
SETUP YOUR ACCOUNT
Follow the instructions in your admin setup email to set up your PROCELL®
InSite account.
PROCELL® InSite
User Guide Website
ISEDC RSS warning
This device complies with Innovation, Science and Economic Development Canada
Compliance licence-exempt RSS standard (s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference,including interference that may
cause undesired operation of the device.
ISEDC Radiation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. This equipment
should be installed and operated with minimum distance 20cm between the
radiator& your body.
FCC statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the partyresponsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator &you body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>