YHW RGB+CCT Living Room Floor Lamp User Manual
- June 17, 2024
- YHW
Table of Contents
YHW RGB+CCT Living Room Floor Lamp
User Manual
SMART FLOOR LAMP (RGB+CCT)
Thank you for your purchase! Please refer this instruction.
PACKAGE CONTENT
Product Parts Description
Assembly Instructions
Notes
During this process, the wire will be entangled with the rotation of the rod,
please tide the direction of the rope to prevent the wire from being cut.
Steps
- Place the light on a flat surface,
- Connect all the parts from lamp head to heavy base.(Steps from 1-5)
- Clockwise and tighten them.
Operating Instruction
- CD Short press : on/off
- Long press : adjust the brightness (1%-100%)
- Long press for 20 seconds : restore factory settings
Rotation angle of the light guide plate
Just manually rotate the lighting plate, which can be rotated up and down by
90 degrees (maximum Angle).
Download Surplife APP
Download “Surplife” App from Apple Store and Google Play Store, or scan the QR
code.
How to connect smart device via Bluetooth?
- Open your phone Bluetooth, turn on device.
- Enter “Surplife” app, click”+ at the top right corner.
- Tap the device with “BLE” on the list, done! (Floor lamp can’t be found? Please reset your lamp)
How to reset the factory setting?
Hold the button on the lamp rod, keep 20 seconds, until the lamp flash, done!
2.4G Remote
Multifunction Keys
- B(Brightness)- In a static light, the brightness will increase/decrease(!. S(Speed)- In built-in dynamic mode:>( ), Speed of the mode will speed up or slow down.
- M(M(Modes): M+ last Dynamic mode, M- next mode.
- “CCT + /CCT-” only works under 2700K-6500K
- S-(Save scenes): Hold the button for 5s, lamp flashing means that you saved this scene to “scene 1” . Even works on multiple lamps with different colors or modes.
Why the remote doesn’t works? (Remote Pair)
- Powering off the lamp, and hold the “( )” key of remote.
- Then power on the lamp, releasing the remote control button until the lamp flashes.
Note : Please pair the remote within 5 seconds after the lamp is powered on.
How to control lamps with 1 remote?
- Power on the lamp which you want to control,
- Then follow the steps of Remote Pairing to add the lamp’s signal to remote one by one
How to remove the remote pairing?
- Pls power off your light, then plug in,
- Hold the key· ( )” until the lamp flashes and release the key.
- The Lamp will flash which means remove Pairing successfully!
Note : Please pair the remote within 5 seconds after the lamp is powered on.
How to control only one lamp?
- Power on the lamp you want to remove out to the remote,
- Then follow the steps of Remote Unpairing, remove the lamp’s signal to remote one by one.
