JACLO 8877 Contempo Round Single Handle Basin Faucet Instruction Manual

Table of Contents

Specifications

Components

Installation

Turn off the water supply to the basin faucet.
Place the rubber washer on the mounting shank.
Insert the mounting shank through the hole in the sink.
Secure the faucet base over the mounting shank.
Thread the mounting nut onto the shank and tighten to secure the faucet in place.
Connect the hot and cold supply lines to the corresponding inlets on the faucet.
Turn on the water supply and check for any leaks.

FAQ

Q: How do I clean the Contempo Round Single Handle Basin Faucet?
- A : To clean the faucet, use a mild soap solution and a soft cloth. Avoid abrasive cleaners or pads that may damage the finish.
Q: Can I use this faucet with a water filter system?
- A : Yes, you can connect a water filter system to the faucet if needed. Ensure proper installation to prevent leaks or damage.

JACLO-8877-Contempo -Round-Single-Handle-Basin-Faucet-
fig1

INSTALLATION

Remove the mounting nut (8), metal washer (7) and rubber washer (6) from the mounting shank (4).
Confirm the mounting shank (4) is tight to the faucet body and slide the faucet base (5) to the bottom of the faucet body.
From above, feed the faucet supply lines (2)(3) and insert the mounting shank (4) through hole in sink.
From below, feed the rubber washer (6), metal washer (7), and mounting nut (8) over the faucet supply lines (2)(3).
Thread the mounting nut (8) over the faucet shank (4).
Tighten the mounting nut (8) to the base of the sink.
Tighten the mounting nut (8) retaining screws until the faucet is secure in the sink.
Connect hot (red)(2) and cold (blue)(3) supply lines to water supply.
Turn on hot and cold water supplies and test for leaks. Adjust accordingly

To learn more about JACLO’s warranty, please visit jaclo.com

Read User Manual Online (PDF format)