PROFLEX 98890 Dual Power Flashlight User Manual

PROFLEX 98890 Dual Power Flashlight

IMPORTANT: ™ Read this manual before using the ProFlex Dual Power Flashlight. Failure to follow these instructions could result in damage to the flashlight, personal injury, or property damage. Safely store this manual for future reference.

Dual Power 500 Lumen LED Flashlight, USB C Charging Cable, 14500 (900mAh) Rechargeable Battery & 1 AA Alkaline Battery Your Police Security® ProFlex'” Dual Power flashlight is perfect far every day use. It provides a powerful, portable light source for use around the home, office, or anywhere you need extra light.

Dual Power:
Powered by a 14500 rechargeable battery or lAA alkaline battery.

Using the ProFlex Lighting Modes:
Press the On/Off switch to turn on the flashlight.
Lightly press the On/Off switch to cycle through the mode sequence.
Model: High
Mode 2: Low

Using Turbo Mode:
Press and hold the On/Off switch for 2 seconds to activate the Turbo Mode. Turbo Mode will run for 30 seconds before going back to previous mode.

Using Slide Focus:
Push the flashlight head away from the body to reveal the spot light / locus beam.
Pull the flashlight head bock to the body to reveal the flood light / wide beam (Image A).

Charging the ProFlex

Unscrew toil cop to remove battery (Image B). The USB C Port is on bollery. Connect the USB C coble to the USB C port to charge the bollery (Image C). The charge indicator light turns red while battery charges. The charge indicator light will turn green when the bollery is fully charged. Install the rechargeable battery by inserting the + sign on the rechargeable battery into the Pro Flex™ flashlight body. Place the toil cop bock on the ProFlex ™ and screw ii to close. To ensure the battery is fully charged, charge your battery using a 5V/2A USB charging adopter and the included charging coble.

Replacement battery available at policesecurity.com

CHARGE TIME UP TO S HOURS

WARNING CHOKING HAZARD
Small parts, Adult Supervision Required. Not Intended for Children under 5 years

Note: Depending on the output of the socket used, the rate and length of charge may vary.
Police Security® cannot be held responsible for any damage or accident caused by using an alternative charging source other than the USB charging cable supplied with this product. Under optimum conditions and with a full charge, the ProFilex” Dual Power flashlight can be used for up to 10 hours.

CHARGE FULLY BEFORE FIRST USE

Safety precautions

• Use only AC USB charging adopters or on appropriate USB power outlet when charging the ProFlex'”. Do not attempt lo charge the ProFlex™ with on adopter that is not compatible as this could result in a fire, damage to the ProFlex'” or personal injury.
• If the USB cable comes into contact with water, place it in a dry location at room temperature, on a soft absorbent towel and allow to dry thoroughly. Do not connect or operate the cable until it is completely free of moisture. Exposure to damp or wet conditions could cause electrocution or damage lo the flashlight.
• Do not charge in combination with any extension cord, electrical generators, or step-up transformers.
• Do not charge in the vicinity of flammable liquids or materials. Always connect to power in a dry and suitable location.

Care and Maintenance

• Store the Proflex” in a clean and dry area. The Proflex™ may also be stored in a vehicle for use in roadside emergencies. If kepi in a vehicle, ii is recommended that battery be recharged periodically to ensure maximum performance in on emergency. Keep in a secure and safe place inside vehicle to prevent damage to the flashlight and battery.
• To clean the Proflex™, wipe with a soft cloth dampened with a soap and water solution. Do not immerse or submerge any port of Proflex” in water or any other solvent. Never use solvents or cleaning agents containing petroleum (petrol, kerosene, oil), paint thinner, turpentine, alcohol, or ammonia. Harsh materials like these can damage surloces.
• All repairs should only be corried out by qualified service personnel. Do not disassemble the ProFlex”, as there ore no user-serviceable ports inside. Opening or visible attempts to open or repair the ProFlex” may cause damage to the product or personal injury. Under normal conditions, LED chips should not wear out and do not need to be replaced. Warranty is negated if ProFlex™ exterior casing is opened.
  • Only use the rechargeable battery included with the product.
  • Using other rechargeable batteries could cause a spark, short circuit or overhealing.
  • Install batteries properly to prevent leaks or product damage.
  • Never attempt to open the battery pack. Liquid ejected from batteries may cause irritations or burns.
  • Remove bollery if light will not be used for on extended period.
  • Fully charge the battery before use.
  • Charge regularly for the best battery life.
  • Do not expose the battery to fire or extreme heat.
  • Never attempt to incinerate batteries as they may leak or explode.
  • Under extreme conditions, liquid may be ejected from the battery.
  • If liquid comes in contact with the skin or eyes, immediately flush the affected area with water and seek medical attention.
    This product contains a Li-Ion bollery formulated from environmentally sensitive materials. This product must be disposed of properly with due core for the environment. Please return this product to your local recycling center for proper disposal.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>