OCTO24 R-Go Riser Duo Tablet and Laptop Stand User Manual

Table of Contents

OCTO24-R-Go-Riser-Duo-Tablet-and-Laptop-Stand-product

Specifications

Setup for Laptop Use:

Step A: Open the document holder.
Step B: Turn the entire stand upside down.
Step C: Grab the top and middle plate of the stand and leave the bottom on the table to open the stand. Put the stand in the desired slot of your height.

Setup for Tablet Use:

To set up the tablet stand, follow steps A, B, and C for laptop use.
Step B: Turn both tablet supports at the same time using both hands.
Step C: Place the tablet supports in the tablet slots.
Step D: Move the tablet supports so that they are clamped around the middle plate. Your tablet stand is ready for use!

For more information about this product, scan the QR code: R-Go Riser Duo.

FAQ

Q: Can I adjust the height of the stand?
- A : Yes, you can adjust the stand to your desired height by placing it in the appropriate slot.
Q: Is this product suitable for both laptops and tablets?
- A : Yes, the R-Go Riser Duo is designed to work as an ergonomic stand for both laptops and tablets.

OCTO24-R-Go-Riser-Duo-Tablet-and-Laptop-Stand-fig1

Step A: Open the document holder (1). Turn the whole stand upside down (2).
Step B : Grab the top and middle plate of the stand and leave the bottom on the table to open the stand.
Step C : Put the stand in the desired slot of your height.
Step D: Lift the top plate of the stand (5). Turn both laptop supports (6). Make sure that both laptop supports are in a 90° angle to the top plate. Lower the top plate and make sure that both laptop supports go into the laptop slot (7).
- Turn the page for instructions on how to set up as a tablet stand.

OCTO24-R-Go-Riser-Duo-Tablet-and-Laptop-Stand-fig3

To set up the tablet stand, first follow steps A, B, and C

Step A : Lift the top plate of the stand until the top plate (1) is at a 90° angle with the middle plate (2).
Step B: Turn both tablet supports at the same time (use both hands).
Step C : Place the tablet supports in the tablet slots.
Step D : Move the tablet supports so that they are clamped around the middle plate. Your tablet stand is ready for use!