horntools HBRRF1613 Roof Rack Ex Roof Instruction Manual
- June 17, 2024
- horntools
Table of Contents
horntools HBRRF1613 Roof Rack Ex Roof
General information
If you have further questions regarding the mounting or the usage of your horntools product feel free to contact us.
Contact your local Hornet dealer
Symbols for dangerous operation
- Whenever this symbol is placed at an installation step special care must be taken. If you don’t follow the instructions you could either damage the product or injure yourself!
- Take a test drive with the car and check that there are no unwanted noises or other unwanted changes in the driveability or behaviour of the car that have occurred since you installed the Horntools components.
- Before installing the horntools product, check if all parts are in the package and are not damaged! If something is missing or damaged contact your horntools dealer and don’t start the installation.
- Read this manual completely, do not start the installation until you fully understand the manual!
- Roof rack ExRoof 1600 x 1250 x 49 mm aluminum black Installation duration: approximately 120 minutes.
Roof Rack DO‘s and DONT‘s
When using a canopy („hardtop”) make sure not to fix the cargo to the roof rack and the Canopy! The roof rack on the cabin and the Canopy can move independently while driving, this can cause damage! So fix the cargo to the roof rack and only support it on the Canopy.
Partlist
Boltlist
Service instructions
- Bolt together the front frame piece with a corner First put together part HBRRF1613_002 with HEXEDGE01.
- To bolt the frame piece together take a slot nut and a washer and secure it with a bolt. The fitting should be as tight as possible.
- Now connect HBRRF1613_003 with the corner piece shown in Abb.
- As shown in Abb.3 assemble the rack with the HBRRF1613_001, the slot nuts are sled in the top side of the extrusion profile! Secure the HBRRF1613_001 with a bolt plus washer from below.
- Repeat this step four more times.
- Complete the assembly with the other parts and bolt everything together.
- Finally, make sure that all corners are aligned at an angle of 90° and that the screws are tightened according to the torque diagram on the last page of these instructions.
Load Capacity
The dynamic load capacity is not the manufacturer‘s release. The
manufacturer‘s load capacity must not be exceeded. The static load indicates
the load capacity at a standstill. The dynamic load capacity refers
exclusively to paved roads. The load must be evenly distributed over a wide
area. Periodically check that the bolts are torqued down properly if needed
torque. Torque down all bolts by the below guidelines
Torque diagram [torque in Nm]
Disclaimer
Outside the scope of application of the Product Liability Act, horntails liability is limited to intent or gross negligence. Liability for slight negligence, compensation for consequential damage and financial loss or personal injury are excluded. horn tools cannot be held liable for improper handling or non-observance of the supplied operating and service instructions. The service may only be carried out by trained specialists or specialist workshops.
horn tools GmbH
Wallenmahd 23
6850 Dornbirn
Austria
T +43 5572 57226
info@horntools.com
horntools.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>