CYCLIQ FLY6 Bike Camera and Safety Lights User Guide
- June 17, 2024
- CYCLIQ
Table of Contents
CYCLIQ FLY6 Bike Camera and Safety Lights
Connect & Charge
- With a supplied USB cable connect your Flyo to a PC or Mac. The middle LED will light until charged
Setting the date and time
- Open the folder containing “CONFIG.TXT” using a text editor
- Modify date and time to suit, in the following format: YYYY/MM/DD HH: MM
- Save the file in the root or main directory (not in the same folder)
- Remove your Fly from the computer – the settings are now saved
- Turn on to have the new settings take effect
Attaching Fly6 to your bike
- Snap seat post mount onto the device
- Take a selection of provided alignment spacers and select the appropriate one, so that your Fly sits perpendicular to the ground
- Once selected, peel off the adhesive backing and affix to the seat post-mount
- Wrap straps around seat post and affix clasps to hooks
Operating your Flyb
Important: Before operating, ensure the USB cover is firmly depressed and seated fully
- Power button
- Turn On/Off (depress for 2 seconds)
- Toggle through flashing sequences (depress briefly)
- Courtesy dimmer (high at start-up)
- Press once for low
- Press twice for no LEDs, only camera (note: the camera’s rotating bezel LEDs are always on when camera is recording)
- Press three times for super bright
NOTE : Should the battery deplete beyond 5% during operation, 3 long beeps will sound, audio and video functions will turn off, and light will continue to operate with remaining power (approx. 1.5 hours). For additional instructions, visit www.fly6.com to download a complete instruction manual.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>