INTERMATIC EI230 In Wall Countdown Timer with Hold Feature Instruction Manual
- June 16, 2024
- Intermatic
Table of Contents
INTERMATIC EI230 In Wall Countdown Timer with Hold Feature
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Risk of Fire or Electric Shock
- Disconnect power at the circuit breaker(s) or disconnect switch(es) before installing or servicing.
- Installation and/or wiring must be in accordance with national and local electrical code requirements.
- Connect to copper conductors only.
- Do not use timer to control devices that could have dangerous consequences due to inaccurate timing, such as sun lamps, sauna, heaters, crock pots, etc.
NOTICE
- No user-serviceable parts.
Ratings
- 15 A General Purpose
- 15 A Resistive
- 1000 W Tungsten
- 1/4 HP Motor
- 500 VA Electronic Ballast
- 1000 VA Ballast
- 120 Vac 60Hz
- Leads: Black-Line, White-Neutral, Red-Load, Green-Ground
Installation
-
Disconnect power to the circuit.
-
Remove wall plate and disconnect light switch.
-
Make sure both “hot” and neutral wires are present in the junction box. (See Fig. 1.)
NOTE: If both wires are not present, additional wiring will be necessary before installation can be completed. Remove insulation from each conductor and make sure ends of wire are straight. -
Connect red timer wire to fixture wire and secure with a wire connector. (See Fig. 2)
-
Connect black timer wire to the “hot” wire in junction box and secure with a wire connector.
-
Cut white wire in junction box (or open splice) and strip 7/16” of insulation on both wires.
-
Connect white timer wire to white wires in junction box and secure with wire connector. (See Fig. 2)
-
Connect the green wire from new timer to the existing ground in box.
-
Verify all wire connections are secure.
-
Place timer and all wires inside junction box.
-
Install the timer and secure with supplied mounting screws.
-
Reconnect electrical power.
Operation
Timer Mode
Press and release timer button repeatedly to select the desired time setting
or to select OFF. The illuminated LED indicates which time setting is selected
and the connected load is turned ON. After the selected time interval counts
down, the LED and the connected load turns OFF.
Hold Mode (Continuous Operation)
To turn timer ON for extended periods of time, press and hold the timer button
for more than 2 seconds.
Timer enters HOLD mode, HOLD LED turns on, and the connected load is turned
ON. To exit HOLD mode press and release the timer button. LED goes off and the
connected load turns OFF.
LIMITED ONE-YEAR WARRANTY
If within the warranty period specified, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original household purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED’s and batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES.
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO
YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. ALL
IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY
OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS
CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE
WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE
DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the
dealer from whom the unit was purchased or (b) completing a warranty claim
online at www.intermatic.com.
This warranty is made by: Intermatic Incorporated, Customer Service 7777 Winn
Rd., Spring Grove, Illinois 60081-9698. For warranty service go to:
http://www.Intermatic.com or call
815-675-7000.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>