LAWA B0BN8JZ44N Firewood Rack Instruction Manual
- June 16, 2024
- LAWA
Table of Contents
LAWA B0BN8JZ44N Firewood Rack
Product Information
Specifications
- Product Name: Firewood Rack
- Manufacturer: LAWALivingAndLifestyle
- Contact Information: info@lawa-lifestyle.de, +49 (0)5424 – 225572
- Website: http://www.lawa-lifestyle.de/
Safety Instructions
Please read the instruction manual carefully before using the firewood rack. The assembly will then be easier for you. Keep the operating instructions for further use.
Only use the firewood rack as described in these operating instructions. Any other use is considered improper and may result in property damage or personal injury. The manufacturer or seller cannot be held liable for any damage caused by improper or incorrect use.
Contact Information
- Email: info@lawa-lifestyle.de (All languages)
- Phone: +49 (0)5424 – 225572 (German)
- Website: http://www.lawa-lifestyle.de/
- Facebook: https://www.facebook.com/LAWALivingAndLifestyle
- Reviews https://www.trustami.com/erfahrung/badarmaturen-welt-de-bewertung
Product Usage Instructions
Mounting
Step 1: Place parts 1 and 2 on the floor in front of you as shown in Figure 1. Screw them together with the screws (C) and the short connectors (I) to be inserted. Please make sure that the outer cross struts (1) are different at the ends than the inner ones (2). In the same way, now connect 2x part 10. These assembled parts will still be needed in a later work step.
Step 2
Attach the corner brackets (III) to the right and left cross struts (#3) and component (#1) using screws (C). Pay attention to the alignment of the corner brackets.
Step 3
Lay the components (4, 8, 6) on the floor and attach the connectors (I) using screws (C). Only now, place the pre-assembled parts (4, 8, 6) upright on the cross struts (3) and transverse bars (1).
Step 4
Secure the parts 5 and 7 to the brackets (III) to assemble parts 3 and the pre-assembled parts 10 from step 1. Use screws C. It is recommended to have a person assist you to prevent part 10 or part 3 from falling during assembly.
Step 5
Build the roof using the remaining square tubes. Start by connecting the connectors (II). Connect the frame at the corners with the inner angle brackets (IV) and screws (A). Insert the polycarbonate panels into the groove until they are fully inserted. Place the aluminium profiles (H) between the individual panels. You can find them in one of the profile parts of the frame.
Step 6
Insert the brackets (III) into the frame profile and connect them with screws (A).
Step 7
Turn the roof upside down so that the flat side is facing up. Lift the roof together and attach it to the corners of the frame using screws (B).
Step 8
Installation is complete. Your firewood rack is now ready for use.
FAQ
- Q: Can I use this firewood rack for other purposes?
- A: No, please only use the firewood rack as described in the operating instructions. Using it for other purposes may result in property damage or personal injury.
- Q: Where can I find reviews of this product?
- A: You can find reviews of this product on Trustami a https://www.trustami.com/erfahrung/badarmaturen-welt-de-bewertung.
- Q: How can I contact customer support?
- A: You can contact us via email at info@lawa-lifestyle.de or call us at +49 (0)5424 – 225572. We are here to assist you.
- Q: Where can I find more information about your products and guides?
- A: Please visit our website at http://www.lawa-lifestyle.de/ to explore our products and guides.
General Information
- Please read the instruction manual carefully before using the firewood rack. The assembly will then be easier for you.
- Keep the operating instructions for further use.
- Only use the firewood rack as described in these operating instructions. Any other use is considered improper and may result in property damage or personal injury. The manufacturer or seller cannot be held liable for any damage caused by improper or incorrect use.
Safety instructions
Keep children, infants and pets away from the assembled firewood rack as they
may attempt to pull themselves up or climb on it. The firewood rack is not a
toy or climbing frame for children. Cleaning and maintenance must not be done
by children. Make sure that children do not play with the packaging, plastic
bags and protective films. Children can get caught in these items while
playing and suffocate. The firewood rack contains small parts (e.g. screws,
nuts and plugs) which pose a choking hazard if swallowed. Keep children,
persons of limited ability and lack of experience or knowledge, and pets away
from the firewood rack during assembly. Do not exceed the maximum load
capacity. Always place the firewood as logs only. Inspect the firewood rack
periodically for loose bolts and nuts, deformation, cracked welds, and other
signs of damage.
Please make sure that the base is straight. Protect yourself and your children
from falling wood. The crossbars should stand securely on your feet and not
bend due to the unevenness of the ground. If a straight surface is not
available, please check the possibility of an independent wall mounting.
Distribute the weight of the firewood sensibly and evenly. This contributes to
a safe stand. The steel frame as well as the polycarbonate roof can simply be
wiped with a damp cloth without using any cleaning agents. After initial
assembly, the surface can be protected and sealed with a wax spray, for
example.
For questions or assistance, please contact us at the following service address:
Mounting
Find a flat, level surface near where you want to place the firewood rack. To be able to adjust the position of the individual parts during assembly, if necessary, wait until the end of the assembly before finally tightening the individual screws. Make sure that the shelf and its frame parts are assembled at right angles. Sort out the individual components and screws before assembly according to the instructions. Consult a second person for the assembly. During assembly, pay attention to the position of the holes, as indicated in the illustrations.
| Illustration | Step |
|---|---|
| 1 | Place parts 1 and 2 on the floor in front of you as shown in Figure 1. |
Screw them together with the screws (C) and the short connectors (I) to be inserted. Please make sure that the outer cross struts
(1) are different at the ends than the inner ones (2). In the same way, now connect 2x part 10. These assembled parts will still be needed in a later work step.
2| Turn the four cross braces over so that the feet point downwards.
3| Use the screws (C) to fasten the corner brackets (III) to the right and
left crossbars (3), as well as to component (1), taking care to align the
corner brackets.
4| Place the components (4, 8, 6) on the floor and attach the connectors (I)
using the screws (C). Only now place the parts (4, 8, 6) you have just pre-
assembled upright on / against the crossbars (3) and cross braces (1).
5| Now you can put the extensions (5, 9, 7) on the just assembled parts (4, 8,
6) and fix them to the connector (I) employing the screws (C).
6| Attach the brackets (III) to struts 5 and 7 to mount parts 3 and the pre-
assembled parts 10 from step 1. Again, use the screws C. Have a person help
you here so that neither part 10 nor part 3 can fall off during assembly.
7| The roof is formed from the remaining square tubes. Start by assembling the
two halves of the roof. These halves will later be connected with the
connectors (II). The frame is connected at the corners with the inside angle
(IV) and screws (A). The polycarbonate sheets are pushed into the groove as
far as they will go. The aluminium profiles (H) are placed between the
individual plates. These can be found in one of the profiles of the frame
parts.
8| Connect the just-assembled halves of the roof by inserting the connectors
(III) into the frame profile and connecting them with the screws (A).
9| Turn the roof over so that the flat side is on top. Lift the roof two by
two onto the shelf and
connect it to the frame at the corners using the screws (B).
PARTS
INSTALLATION INSTRUCTIONS
- If you have purchased a tarpaulin for your product, it is attached to the shelf through the eyelets and the elastic bands.
- Please open the tarpaulin in good weather to ensure optimal air circulation.
- Do you still need a tarpaulin set afterwards? Please feel free to contact us.
CONTACT
- https://lawa-lifestyle.de
- Alle Farben – Alle Größen
- All colors – All sizes
- Všetky farby – Všetky veľkosti
- info@lawa-lifestyle.de –> Pošlite nám e-mail (všetky jazyky)
- +49 (0)5424 – 225572 –> Tešíme sa na váš telefonát (nemčina)
- http://www.lawa-lifestyle.de –> k našim produktom a sprievodcom
- https://www.facebook.com/LAWALivingAndLifestyle –> Zistite a sledujte nás na Facebooku
- https://www.trustami.com/erfahrung/badarmaturen-welt-de-bewertung –> Všetky recenzie na Trustami
References
- lifestyle.de - This website is for sale! - Lifestyle Resources and Information.
- LAWA Living and Lifestyle｜Dirks-Traumbad - seit 20 Jahren | LAWA Living and Lifestyle
- LAWA Living and Lifestyle｜Dirks-Traumbad - seit 20 Jahren | LAWA Living and Lifestyle
- LAWA Living and Lifestyle｜Dirks-Traumbad - seit 20 Jahren | LAWA Living and Lifestyle
- LAWA Living and Lifestyle Bewertung & Erfahrung auf Trustami