Anelto SIM7500A Fdd Hspa Module User Guide

Anelto- SIM7500A
User Guide
Version 1.0

Introduction

This document gives the usage of SIM7500A, user can get useful information about the SIM7500A quickly through this document.
This document is subject to change without notice at any time.
1.1 Acronyms and abbreviation
Table 1: Acronyms and abbreviations

2.1 Detailed description of SIM7500A
This chapter introduces the functions of each component. The components C/D/G are the MAIN_ANT/ GNSS_ANT / AUX_ANT SMA connectors, and the connectors B/E/F are reserved for dug.A: USB interface, support USB communication with SIM7500A.
B: AUX_ANT RF connector
C: AUX_ANT SMA connector.
D: GNSS_ANT SMA connector.
E: GNSS_ANT RF connector.
F: MAIN_ANT RF connector.
G: MAIN_ANT SMA connector
H: GNSS Antenna
I: MAIN and AUX Antenna

Regulatory Compliance: FCC/IC

The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the United States FCC regulations and has an Industry Canada registration (IC ID) of 20951-ANH0823. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
FCC ID: 2AGPI-ANH0823
IC: 20951-ANH0823 Model No: SIM7500A

Regulatory Compliance: RF Exposure
Your device is a radio transmitter and receiver. It is designed and manufactured not to exceed the emissions limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S. Government and has an Industry Canada registration (IC ID) of 20951-ANH0823. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. These guidelines are based on the safety standards previously set by the U.S. and international standards bodies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health.
The exposure standard for wireless RF devices, such as the device, employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. SAR values at or below that limit is considered safe for the general public.
Before a wireless RF device is made available for sale to the Public, it must be tested and certified to the FCC that it does not exceed the SAR limits established by the FCC. Tests for SAR are conducted using the positions and locations (e.g., at the ear or worn on the body) as required by the FCC for each device model.
The device has been tested and meets the FCC RF exposure guidelines when used against the body under normal usage conditions.

REVISION TABLE:

Anelto Sim7500A User Guide

Documents / Resources

| Anelto SIM7500A Fdd Hspa Module [pdf] User Guide
SIM7500A Fdd Hspa Module, SIM7500A, Fdd Hspa Module, Hspa Module, Module
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>