H2Wellness TRY 4088 Molecular Hydrogen Water Bottle User Manual
- June 16, 2024
- H2Wellness
Table of Contents
H2Wellness TRY 4088 Molecular Hydrogen Water Bottle User Manual
The most innovative technology:
- Proton Exchange Membrane (PEM) technology from Japan
- State of the art Solid Polymer Electrolysis (SPE) technology
- Works with all types of drinking water including Distilled and RO
- Separates and expels harmful by-products of Chlorine, Ozone and Oxides
- Produces the highest industry levels of molecular Hydrogen concentrates
- Uses safest high-quality Korean Platinum coated Titanium Electrode Plates
- Best portable generators in the industry
- No filters or any expensive parts to replace
Product Diagram:
Quick Start Guide
Set Up:
-
Wash glass/plastic bottle and lid with warm water. Remove bottle from generator firstly then wash the bottle glass/plastic container.
-
Twist plastic plug off on the electrode plate.
-
Twist glass/plastic bottle on to generator.
-
Cap bottle with lid and insert USB cable into USB Port.
Insert other cable end to power plug and plug it into outlet. -
Charge Unit for 2-3 hours until green light turn on then take off charger.
-
With bottle attached rinse out Generator with warm water.
-
Fill bottle up to 90% of the bottle with clean drinking water.
-
Operate generator to make hydrogen-rich water.
To Operate:
- Press power button. The working indicator light will turn blue, making hydrogen-rich water for 3 minutes. Press the button for twice quickly in a row will turn the working mode to be 10 minutes. Pressing button when unit is working will turn power off.
- After a 3 or 10 minutes cycle the working indicator blue light will turn off, completing process. For higher concentration of H2, use the 10 minutes cycle.
- You can drink the hydrogen-rich water directly out of the bottle or pour it into another container. It is best to drink water within one hour. Hydrogen will dissipate over time.
- Self-cleaning: Press and Hold the switch button for three seconds , the working indicator light turn green, the positive and negative electrodes will be swapped and the machine will enter the automatic self-cleaning mode.
- Charging: If the working indicator light flashes blue, this means the battery power is low and needs to be charged. Plug the USB power adapter (Mobile phone charges) into the wall and plug the USB power cable into the adapter, the indicator light on the power button turn red when it is charging. The charging micro USB charging port is located underneath the rubber cover on the generator base. When charging is complete, make certain the rubber cover is inserted into the micro USB port. This will keep water from entering the base and electronics. When charging is complete, the red indicator light will turn green.
The battery has an expected life of 500 charges. Keeping your machine plugged in all day during use may prematurely cause your battery to fail sooner. It is ok to finish cycling to operate while charging if your battery dies during operation, but do not use again until battery fully charges and light stops blinking. Do Not Keep Plugged In.
- Inhaler usage: Remove the rubber protector from the port(Install the rubber protector onto its origin port after inhalation),then open the rubber cover on the cap, attach the Cannula breathing tube to the Cap-Lid by slipping the Cannula tubing end with the open end onto the snorkel valve protruding in the center of cap. Fill machine bottle ¾ of the way full of water and screw on cap to the top of the bottle with the Cannula breathing tube attached.
Place the loop end of the Cannula tube over your head and the two breathing prongs into each nostril and adjust the slack-bead behind neck to be snug against the back of your head.
Daily Use:
- Never leave plugged in while using during the day. Always discharge the battery some or all before recharging.
- For maximum benefit drink 4 – 5 bottles or more per day.
- Use any clean purified water when possible to keep plates clean.
- Never let the Generator dry out and leave a little water to keep the electrode plate moist.
- Do self-cleaning one time every week. Self-cleaning water can not drink, just pour away.
Advisories:
- Never operate Generator without water in the bottle.
- Keep USB Port sealed by plugging its cover back in.
- Operate only with any type of clean drinking water.
- Not for use with hot, carbonated or other beverages.
- Always keep Generator Plate Well wet and never store dry.
- Unit will stop charging when LED lights turn green.
- Do not place Generator unit in a refrigerator or cooler.
- Do not soak or submerge Generator Unit under water.
- Operate only for the water you will drink in one hour.
- Avoid direct sunlight or heat that can dry out the plates.
- Use room temperature water. Never freeze or use ice.
- Never use any chemical cleaners on Generator unit.
- Keep away from children, Pets, Heat and Flames.
- Do not pull cable from wire or plug with wet hands
Occasional Descaling Maintenance:
Depending on the mineral oxide content in your drinking water, clean the
electrolysis plates by descaling once a month if necessary. To descale simply
add 1 part either white vinegar, lemon juice or citric acid to 3 parts water
into the bottle and leave generator soaking in mix overnight.
Dump and rinse thoroughly with warm water before using again.
Disclaimer: These Products have not been evaluated and are not intended to diagnose, cure, treat or prevent disease. Seek medical advice if seriously ill and or attempting to cure or prevent disease.
Trouble Shooting
Warranty: One Year due to defective Parts or Labor
Product Specifications
Quick Guide:
Press Power Button 1 time = 3 Minutes Cycle (Blue LED Light), light off means
completed
Press Power Button 2 times = 10 Minutes Cycle (Blue LED Light), light off
means completed
Press & Hold Power Button = Self Cleaning (Green LED Light), light off means
completed
To Cancel: Press Power Button again.
Blinking Blue LED Light = Please charge the Bottle.
Green LED Light On = Charging is Completed.
WARNING!!! Stop Use and Ask a doctor if:
*Any discomfort feeling appears
Please Remember:
Inhaling hydrogen differs from oxygen inhalation. Please don’t mistake this
bottle as ineffective just because you don’t feel anything while inhaling H2.
Hydrogen Inhaler Directions
Please consult your doctor before using Hydrogen Inhaler!
For first time user, start inhalation process for 10 minutes per day.
Slowly increase the time to 13 minutes per day in the week 2.
Increase the time to 20 minutes in the week 3, and so on.
Do Not Rush to achieve hydrogen.
Youth can increase the time quickly; the elderly should be as slow as
possible.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>