KWD W1 Bluetooth Receiver User Manual
- June 16, 2024
- KWD
Table of Contents
W1 Bluetooth Receiver
User Manual
W1 Bluetooth Receiver
W1 Bluetooth receiver
Thank you very much for buying this product. You are advised to read this user manual carefully before using this product to ensure correct use.
Function Introduction:
1)Used for car speaker and old-fashioned speaker and so on device, connect
with phone Bluetooth
2)3.5mm interface metal AUX plug
3)120 mAh battery, support Type-C, working time time is about 6 hours after
fully charged.
Support hands-free calling
Technical parameters:
Working voltage: 5V
SNR>60DB
Distortion: <0.1%
Bluetooth version: V5.3
Bluetooth sound processing: A2DP (Advanced Audio Distribution Mode) function
support
Bluetooth transmission distance: 5 meters
Bluetooth microphone effective distance: 0.5-2 meters
Attention:
When this product is not used for a long time, it should be unplugged from the
equipment jack, not in high temperature, dust or humid environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
The devices has been evaluated to meet general RF exposure requirement the
device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>