RING RTC450 Digital Tyre Inflator with Auto Stop Memory LED Light Instruction Manual
- June 16, 2024
- Ring
Table of Contents
RING RTC450 Digital Tyre Inflator with Auto Stop Memory LED Light
Introduction
Intended Usage
The intended use for this product is inflation of vehicle tyres and other
stated inflatables. It can also be used to deflate the stated inflatables. It
is only intended for private use and not suitable for commercial purposes. Use
of this product in any way other than described is considered improper and may
result in damage to property or persons. The manufacturer or vendor cannot be
held liable for damages or injury incurred through improper or incorrect use.
For list of General Power Tool Safety Warnings please scan the QR code or
visit:www.ringautomotive.com/en/product-safety-
documents
Explanation of symbols
Pay attention
Attention
Refer to instructions for
information.
File instructions for
future reference.
Requires 12V d.c. power.
The noise level of the
product is 90 dB. Wear hearing protection. The impact of noise can cause
damage to hearing.
Correctly inflated tyres will reduce fuel consumption and result in lower CO2 emissions.
Introduction
Please ensure to fully unwind the power cable before use to avoid
overheating.
Control layout
| | |
---|---|---|---
| | | |
Operation
NOTE: The gauge on this compressor is for guidance only. Check pressure with a known accurate gauge. The compressor can be used without the engine running but this will drain the power from the battery.
Inflatable and Leisure Inflation
| 5-13PSI / 0.34-0.90BAR
---|---
| 22PSI / 1.52BAR
| 35-50PSI / 2.41-3.50BAR
| 90-1 00PSI / 6.20-6.90BAR
Specifications
| Power supply | 12V d.c. |
|---|---|
| Max Amperage | 10A |
| Pressure measurement range | 0-99 PSI / 0-6.9BAR |
| Decibel rating | 90dB |
| Product dimensions | L197 x W80 x H180mm |
| Power cable length | 3m |
| Air hose length | 50cm |
| Operation temperature | -1o·c to +so·c |
Declaration of Conformity
The UK Conformity Assessed mark identifies products conforming with the statutory requirements (refer to “Declaration of Conformity”)
The EU Conformity Assessed mark identifies products conforming with the
statutory requirements (refer to “Declaration of Conformity”)
The UKCA / CE declaration of conformity is available on request from
technicalsupport@ringautomotive.com
Customer Support
Manufactured by: Ring Automotive Limited Gelderd Road, Leeds, LS12 6NA
United Kingdom
Telephone +44 (0) 113 213 2000 . Fax +44 (0) 113 231 0266
Email autosales@ringautomotive.com
www.ringautomotive.com
Authorised Representative: OSRAM GmbH Nonnendammallee 44, 13629 Berlin,
Germany
Email: automotive-service@osram.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>