WHLED 400W LED Parking Lot Light Instruction Manual

June 16, 2024
WHLED

LED PARKING LOT LIGHT

INSTALLATION INSTRUCTIONS

  • Warning: Do cut off electrical source to avoid electrical shock before installation.
  • Installation height should be higher than 1.2m.
  • For pole mounting, please complete wiring at accessible handhole on pole.

Step 1: Start installation
Turn the street light to back side, loose the screws on swivel
Step 2: Connect cables
Connect the L, N, GND cables of the lamp to the corresponding , N, GND cables of lamp pole.
Step 3: Fix lights to lamp pole
Install the light to lamp pole, fasten the screws on the swivel. Adjust the light to an angle you need.

ELECTRICAL CONNECTIONS-100-240V/277V AC, 50/60HZ PHASE TO NEUTRAL WIRING

Step1:
Make the following electrical connections:
a. Connect INPUT GROUND conductor to GREEN WIRE position of the terminal block or GROUND conductor of LED driver.
b. Connect INPUT VOLTAGE conductor to BROWN WIRE position of the terminal block or LINE conductor of LED driver.
c. Connect INPUT NEUTRAL conductor to BLUE WIRE position of the terminal block or NEUTRAL conductor of LED driver.
STEP 2: Make sure all excess input wires are pushed into pole, screws are tightened.
STEP 3: Close cover by firmly pushing cover towards fixture, making sure It hat no wires are pinched and Sealing gasket are fully engaged.
STEP 4: I F the fixture without a terminal block, please insulate all electrical connections with wire nuts suitable for at least 90 .

Input cable should be at least H05RN-F 3×1.0m SJTW 18AWG) or outdoor grade cable with rubber sheathed(not supplied). The cable must have a minimum cross sectional area of 1.0 m SJTW 18AWG).WHLED 400W LED Parking Lot Light -
FIXURE WIRING

  • If the fixture with built-in 3 in 1 dimming function, Please connect INPUT POSITIVE(+) SIGNAL CONDUCTOR TO DIM+(BLUE WIRE), INPUT NEGATIVE(-) signal conductor to DIM-(WHITE WIRE) of LED driver.WHLED 400W LED Parking Lot Light - Round PoleIf you need a dusk-to-dawn function, please remove the photocell sensor cap

WHLED 400W LED Parking Lot Light - photocellPlease remove the cap if you need the photocell sensor, or just keep it covering the sensor if you don’t

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals