ROWENTA IS3421U1 Expert Style Steamer Instruction Manual

: June 16, 2024
: Rowenta

Table of Contents

ROWENTA IS3421U1 Expert Style Steamer
Specifications
IMPORTANT SAFETY INSTRUCTIONS
Before first use
TROUBLESHOOTING
PRODUCT DESCRIPTION
ASSEMBLY
ACCESSORIES
USE
AFTER USE
DESCALING PROCEDURE
CLEANING
FAQ
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ROWENTA IS3421U1 Expert Style Steamer

Specifications

Model: Central de vapor IS34xx
Voltage: 120 V
Frequency: 60 Hz
Power: 1500 W

Environmental Protection
Your appliance contains valuable materials that can be recovered or recycled. Leave it at a local civic waste collection point.

IMPORTANT SAFETY INSTRUCTIONS

When using your appliance, basic precautions should always be followed, including the following:
Read all instructions before using this product.
This product has been designed for domestic and indoor use only. Any commercial use, inappropriate use, or failure to comply with the instructions, the manufacturer accepts no responsibility and the warranty will not apply.
WARNING! The voltage of your electrical outlet must correspond to that of the appliance (120V). Connecting to the wrong voltage may cause irreversible damage to the steamer and will void the warranty.
Use the appliance for its intended use only.
To reduce the risk of contact with hot water emitting from steam vents, check the appliance before each use by holding it away from the body and operating the steam button.
Never pull on the cord to disconnect the appliance from the electrical outlet; instead, grasp the plug and pull to disconnect the appliance.
Do not allow the cord to touch hot surfaces. Let the appliance cool completely down before putting it away. Loop the cord loosely around the appliance when storing.
Always disconnect the appliance from the electrical outlet when filling with water or emptying, and when not in use.
Do not operate the appliance with a damaged cord or if the appliance has been dropped or damaged. To avoid the risk of electric shock, do not disassemble or attempt to repair the appliance. Take it to the nearest authorized service center for examination and repair. Incorrect reassembly or repair could cause a risk of fire, electrical shock, or injury to persons when the appliance
is used.
Close supervision is necessary for any appliance being used by or near children.
Do not leave the appliance unattended while plugged in or while it is still hot.
Burns could occur from touching hot metal or plastic parts, hot water, or steam.
Care should be taken when using the appliance due to the emission of steam.
Completely extend at the maximum the pole before using.
Always use the appliance with the steam hose in a vertical position.
Use care when you empty a steam appliance. There may be hot water in the reservoir.
To reduce the likelihood of circuit overload, do not operate another high-voltage appliance on the same circuit.
If an extension cord is necessary, a cord with a 15A ampere rating should be used. A cord rated with less amperage can result in a risk of fire or electric shock due to overheating.
Use caution when placing the cord, so that it cannot be pulled or tripped over.
To protect against the risk of electric shock, do not immerse the appliance in water or other liquids.
Do not direct steam at people, animals, or clothes while they are being worn.
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The use of other accessory attachments than those provided by the manufacturer is not recommended and may result in fire, electric shock, or personal injury.
The appliance must not be used if it has been dropped, if there are visible signs of damage, or if it is leaking.
Check the electrical cord for signs and wear or damage before use. If the electrical cord is damaged, it must be replaced at an approved service center to avoid any danger.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.(depending on the model)

CAUTION: The surfaces that are marked or close to this sign are very hot during the use of the appliance. Do not touch these surfaces before the appliance has cooled down.

Before first use

When you first use the appliance, some smoke or a harmless odor may be produced or there may be a small discharge of particles. This will not affect the use of the appliance and will disappear quickly.

What water to use?
Your appliance has been designed to use tap water. If your water is very hard, mix 50% tap water and 50% bottled demineralized water. Never use water- containing additives (starch, perfume, aromatic substances, softeners, etc.), or condensation water (for example water from tumble dryers, water from refrigerators, water from air conditioning units, rainwater). This water contains organic waste materials or minerals that concentrate under the effect of heat and cause spitting, brown coloring or premature aging of your appliance.

SAVE THESE INSTRUCTIONS

TROUBLESHOOTING

Problems	Possible causes	Solutions
There is no steam.	The appliance has not been turned on.	Check that the

appliance has been plugged correctly. Then turn the knob for power on. The power indicator light located on the knob will light on.
The hose has been obstructed.| Check that the hose is not bent or twisted.
There is no water left in the water tank.| Switch off the device and fill the water tank.
The steam is not ready yet.| The appliance will produce steam about 45 seconds after it has been switched on.
The steam flow is low.| Your steamer has a

build-up of scale because it has not been rinsed out regularly.

| See the descaling process paragraph.
The hose has been obstructed.| Check that the hose is not bent or twisted and check the pole is completely extended.
There is no water left in the water tank.| Switch off the appliance and fill the water tank.
Water runs through the holes of the steam head.| There is condensation in the hose.| Never use the steam head in the horizontal position. Hold the hose vertically outstretched, wait for the condensed water to return to the steamer and check the pole is completely extended.
The steamer takes a long time to heat and/or eject white particles.| Your steamer has a

build-up of scale because it has not been descaled regularly.

| See the descaling process paragraph.

ENVIRONMENTAL PROTECTION FIRST

Your appliance contains valuable materials that can be recovered or recycled.
Leave it at a local civic waste collection point.

PRODUCT DESCRIPTION

Hanger / Steam head holder
Steam Head
Steam hose and locker
Adjustable poles, locks, and adjustable support vertical hook
ON / OFF Button and Steam Control
Removable Water tank
Draining Cap
Vertical Support*
Fabric Brush*
Hanger & clips*

ROWENTA-IS3421U1-Expert-Style-Steamer-FIG-2

ASSEMBLY

Insert the pole in the housing until
you hear a “click”.
Open the three-pole locks.
Extend the pole fully.
Close the three locks.

Fully insert the hanger/holder vertically on top of the pole and lock it.
Position the steam head on its cradle.
Insert the steam hose, and lock it, by screwing until hearing a “click”.
Add the vertical support* and the hanger.
Unwind the support and fix it, by adjusting the tension with the dedicated hook and screw.

BEFORE USE

Remove the water tank.
Remove the cap then fill in the water tank.
Fully screw the water tank cap and insert the tank back in the appliance.
Add the garment of your choice on the hanger or a separate hanger.

ACCESSORIES

WARNING: Accessories must be settled when the appliance is cold and not running.

The fabric brush* opens the weaves of the fabrics for better steam penetration.

USE

The appliance must remain in a horizontal position on the floor
Plug in the appliance.
Turn the On/Off Button, to switch on the appliance. Then, adjust the steam output by turning the button. After 45 seconds approximately, steam will come out.
For optimal use, pass the steam jets on your garment from top to bottom.
Never steam directly on people.

AFTER USE

Turn the on/off button to the “OFF” positioning, to switch off the appliance.
Unplug the appliance.
Remove the water tank.
Unscrew the cap and then empty the water tank in a sink.
Screw back the cap and place the water tank back to its appliance.
Roll up the power cord and place it on EN its hook.
Wait for an hour for your appliance to cool before storing.

ROWENTA-IS3421U1-Expert-Style-Steamer-FIG-11

DESCALING PROCEDURE

To apply every 6 months or in case of performance decrease.

WARNING : Wait an hour or until the appliance is completely cooled down.
Remove the steam head from the cradle, unlock & collapse the pole.
Remove the water tank.
Fill .5L(Liter) of water in the appliance EN water tank. entrada del tanque de agua.
Gently shake the base of the product EN to remove particles.
Place the appliance over a sink & unscrew the «Anti-calc» cap by turning it anti-clockwise.

WARNING: Be careful, water might be hot.

Vertically tilt the appliance to empty EN mix in a sink
Put the anti-calc cap back and fully screw it to prevent leaking*.
Unlock the pole, extend, lock.
Position the steam head on its cradle.
Remove the cap then fill in the water tank.
Fully screw the water tank cap and insert the tank back into the appliance.
Plug in the appliance and switch it on.
Let the appliance run until the water tank is emptied.

CLEANING

Wait an hour for a complete cool-down
Only use a sponge with water to clean the base.
Only use a sponge with water to clean the steam head
Never use detergents when cleaning your appliance.
Never wash or rinse appliances directly over a sink

FAQ

Q: What water should I use with the appliance?

A: It is recommended to use clean tap water for the operation of the appliance.

Q: Why is there no steam coming out of the appliance?

A: There could be several reasons for this issue. First, make sure the appliance is turned on and plugged correctly. Check if the hose is bent or twisted. Also, ensure there is enough water in the water tank and wait for about 45 seconds after turning on the appliance for the steam to be produced.

Q: How do I remove scale buildup from the steamer?

A: To remove scale buildup, refer to the descaling process paragraph in the user manual. Regular descaling is important to maintain optimal performance.

Central de vapor
Modelo IS34xx
120 V ~ 60 Hz 1500 W

Importado por