LAP Ayllon TP68-4218WS-WH LED Batten Instruction Manual

June 16, 2024
LAP Ayllon

LAP Ayllon TP68-4218WS-WH LED Batten

LAP Ayllon TP68-4218WS-WH LED Batten

IMPORTANT

These instructions are for your safety. Please read through them thoroughly prior to handling the product and retain them for future reference.

Parts

Parts

You will need

You will need

Care & maintenance

Care & Maintenance

Safety

  • IMPORTANT Do not use with a dimmer switch.
  • IMPORTANT, Retain for future reference: read carefully
  • These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference.
  • All fittings must be installed by a competent person in accordance with local regulations (IET wiring regulation BS7671).
  • Check the pack and make sure you have all of the parts listed.
  • Remove all packaging, wrap etc from the product.
  • Decide on the appropriate location for your product.
  • CAUTION: IP65 is guaranteed when the product is properly installed and sealed.
  • Always avoid the product to be located at corrosive environment.
  • Always refer to the installation drawing for the orientation of the product.
  • The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings not supplied and must be purchased.
  • Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
  • IMPORTANT: The fixing point(s) selected must be capable of supporting the full weight of the light fitting.
  • CAUTION: Ensure the cable is routed so it does not present a hazard (avoid dangling loops where the cable is likely to be pulled/caught).
  • Maximum number of interconnected with same model: 9 pcs.
  • Wiring diagram is for reference only. Always refer to the terminal marking for wiring. Ensure that all electrical connections are tight and that no loose strands are left out of the terminal block.
  • Use round cable only.
  • Ensure the connection is tightened, to create a good water seal.
  • The round main cable should be at least 6.8 mm in diameter.
  • Never put anything on the product or hang anything on any part of this product.
  • Never use the terminal cables to bear the product weight.
  • This light use microwave motion detection, it may detect occupants through doors, glass windows or thin walls.
  • Non-replaceable control gear.
  • When the product does not light after installation:
  • Ensure there is no electricity failure
  • Ensure all the connections are secured
  • If you have any doubt about installation/use of this product, consult a qualified electrician.
  • Always disconnect the product from mains at least 10 minutes allowing to cool down before any maintenance or adjustment.
  • It is recommended to have a regular schedule of care and maintenance to keep the surface condition well.

Technical Data

Supply voltage:

| 220-240 V—, 50 Hz
---|---

Bulb type:

| 1 x Max. 36 W (check bulb dimensions in relation to space available).
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Do not stare at the operating light source.

Frequency range:

| 5725 MHz – 5875 MHz

Transmitter power:

| <1m W
| This product complies with conformity requirements of the applicable European Regulations or Directives.
| This product complies with conformity requirements of the applicable UK Regulations.

Energy efficiency class:

| This product contains a light source of energy efficiency class .
Symbol| Class II product – Double Insulated – No earth required.

IP65

| Jet-proof
| Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
---|---
| Do not use with a dimmer switch.

xxWyy:

| xx-year; yy-week of the year

Guarantee

We take special care to select high quality materials and use manufacturing techniques that allow us to create products incorporating design and durability. This product has a manufacturer’s guarantee of 5 years against manufacturing defects, from the date of purchase (if bought in store) or date of delivery (if bought online), at no additional cost for normal (nonprofessional or commercial) household use.
To make a claim under this guarantee, you must present your proof of purchase (such as a sales receipt, purchase invoice or other evidence admissible under applicable law), please keep your proof of purchase in a safe place. For this guarantee to apply, the product you purchased must be new, it will not apply to second hand or display products. Unless stated otherwise by applicable law, any replacement product issued under this guarantee will only be guaranteed until expiry of the original period guarantee period.
This guarantee covers product failures and malfunctions provided the product was used for the purpose for which it is intended and subject to installation, cleaning, care and maintenance in accordance with the information contained in these terms and conditions, in the user manual and standard practice, provided that standard practice does not conflict with the user manual.
This guarantee does not cover defects and damage caused by normal wear and tear or damage that could be the result of improper use, faulty installation or assembly, neglect, accident, misuse, or modification of the product. Unless stated otherwise by applicable law, this guarantee will not cover, in any case, ancillary costs (shipping, movement, costs of uninstalling and reinstalling, labour etc), or direct and indirect damage.
If the product is defective, we will replace or refund, within a reasonable time.
Rights under this guarantee are enforceable in the country in which you purchased this product. Guarantee related queries should be addressed to the store you purchased this product from.
The guarantee is in addition to and does not affect your statutory rights.

(UK) DECLARATION OF CONFORMITY


Product

  • AYLLON / LAP Hanging Batten Link Sensor WH / BLK
  • TP68-4218WS-WH / TP68-4218WS-BLK

Name and address of the manufacturer or his authorised representative:
Kingfisher International Products Limited 1 Paddington Square
London W2 1GG
United Kingdom
This declaration of conformity is issued under the sole responsibility of the manufacturer.
Object of the declaration
Product| Model| EAN
AYLLON Hanging Batten Link Sensor WH
AYLLON Hanging Batten Link Sensor BLK
LAP Hanging Batten Linkable with Sensor White| TP68-4218WS-WH
TP68-4218WS-BLK TP68 4218WS-WH| 5063022044297
5063022044303
5063022047373
The object of the declaration described above is in conformity with the relevant legislation:
Radio Equipment Regulations 2017 as amended
The Restriction of the use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 as amended
The Ecodesign for Energy-Related Products and Energy Information Regulations 2021
Electrical Equipment (Safety) Regulation 2016 as amended Electromagnetic Compatibility Regulations 2016 as amended
References to the relevant designated standards used or references to the other technical specifications in relation to which conformity is declared:

  • EN 300 440 V 2.2.1
  • EN 301 489-1 V2.2.3
  • EN 301 489-3 v2.1.1
  • EN & BEEN 50665:2017
  • EN & BEEN, IEC 55015:2019+A11:2020
  • EN & BEEN 61547:2009
  • EN & BSEN, IEC 61000-3-2:2019+A1:2021
  • EN & BEEN 61000-3-3:2013+A1:2017+A2:2021
  • EN & BEEN IEC 60598-1:2021
  • EN & BEEN 60598-2-1:2021 EN & BEEN 62493:2015
  • EN IEC 62031:2020
  • EN 62471:2008 & 62778:2014
  • EN 61347-1:2015
  • EN 61347-2-13:2014/A1:2017
  • EN 61347-2-11:2001/A1:2019

Signed for and on behalf of: Kingfisher International Products Limited 1 Paddington Square London W2 1GG, United Kingdom
David Awe
Group Quality Director 08/11/2022

EU DECLARATION OF CONFORMITY


Product

  • AYLLON / LAP Hanging Batten Link Sensor WH / BLK
  • TP68-4218WS-WH / TP68-4218WS-BLK

Name and address of the manufacturer or his authorized representative;
Kingfisher International Products B.V., Rapenburgerstraat 175E,1011VM Amsterdam, The Netherlands
This declaration Is Issued under the sole responsibility of the manufacturer
Object of the declaration
Product| Model| EAN
AYLLON HangingBanen
Link Sensor WH| TP68-4218W$-WH| 5063022044297
AYLLON Hanging Batten
Link Sensor BLK| TP68-4218WS-BLK| 5063022044303
LAP Hanging Banner Link able with Sensor White| TP68-4218WS-WH| 5063022047373
The object of the declaration described above is in conformity with the relevant union harmonisation legislation:
2014153/EU as amended Radio Equipment Directive

  • EN 300 4 40 V 2.2.1
  • EN 301 48 9-1 V 2.2.3
  • EN 301 489-3 v2.1.1
  • EN 50665:2017
  • EN IEC 55015:2019+A11:2020
  • EN 61547:2009
  • EN IEC 61000-3-2: 2019+A1:2021
  • EN 61000-3 -3:2013+At 2017+A2:2021
  • EN IEC 60 598-1:2021
  • EN 60598-2-1:2021
  • EN 62493:2015
  • EN IEC 62031:2020
  • EN 62471:2008 & 62778 :2014
  • EN 61347-1:2015
  • EN 61347-2-13:2 014/A1:2017
  • EN 61347-2-11:2001/A1:2019

Signed for and on behalf of: Kingfisher International Products B.V., Rapenburgerstraat 175E, 1011 VM Amsterdam, The Netherlands
David Awe
Group Quality Director 08/11/2022

Manufacturer

Installation

  • IMPORTANT DO NOT USE WITH A DIMMER SWITCH.
  • IMPORTANT! RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
    Installation
    Installation

L = Brown or Red
N = Blue or Black

Installation
Installation
Installation
L = Brown or Red
N = Blue or Black
Installation

Installation

  • IMPORTANT DO NOT USE WITH A DIMMER SWITCH.
  • IMPORTANT! RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
    Installation

Installation
Installation
Installation

L = Brown or Red
N = Blue or Black
Installation

Installation
Installation
L = Brown or Red
N = Blue or Black

Installation
Installation

  • Maximum number of interconnected with same model: 9 pcs
    Installation

  • This light use microwave motion detection, it may detect occupants through doors, glass windows or thin walls.
    Installation

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals