Mingxin M3 MiNi Speaker User Manual
- June 16, 2024
- Mingxin
Table of Contents
M3 MiNi Speaker
User Manual
M3 MiNi Speaker
- Speaker
- Color LED indicator
- Microphone hole
- Charge LED indicator
- Micro USB socket
- On/Off Button
- Hole for umbilical cord
Usage:
Press and hold the bottom power button to turn on the phone (with a power-on sound and a blue light flashing), then refresh the Bluetooth settings page of the phone to find the Bluetooth name: MT or M3. The Bluetooth name that can be inserted into the card is MTTF or M3TF (if a card is inserted, remove the card first), and click to connect
Charging the battery:
-
inset the changing Cable into the Micro USB input port,connect the USB plug into 5V USB power termninal.
The charging ED indicator will turm on. -
Atter tharging compeleted, the LED incicaor wil turr off
Note: When music sound becomes smaler and you hear the warning tone, please charge this speaker in time.
Wireless pairing for musit/phone call
-
a. Turn ont the peaker by pressing**buttor for 3 secands. he speaker will have a vaice prompt and biue indicator will lash.
b. Stereo mode (only for two speakers):
Power an twa Model. Double press ” ” on any Model. connected prompts are heard once the speakers are paired successuly. After the frst pairing, the Model wiygutomaticaly connect when you urni them both on -
Turn in your device and activate the Bluetcoth unction.
-
Search for Wireless psiring name *Model and click to pair, the speaker will ait automatically and the speaker will have a voice prompt, the bhe indicator will light on, Then. you just need press “ ” button to answer the cal when he call is coming or press for play/pause.
-
Tum off the speaker by pressing “ ” buron for 4 seconds and the speaker will have a voikce prompt.
NOTE: When you can’t piay the music, peaserefreshthe Wireless connection.
Specification
| Power Rating | 3W |
|---|---|
| Frequency Response | 20Hz- 20KHz |
| THD | <1 % |
| S/N | ≥ 80DB |
| Speaker Parameter | 4Ω 3W Diameter 36mm |
| Battery | 3.7V/200 450mAh |
| Wireless Version | Wireless V 5.0 |
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.