Mostery x13 Blackhead Remover Pore Vacuum User Manual

x13 Blackhead Remover Pore Vacuum
User Manual

In order to avoid the injury caused by misuse, please read the instructions carefully before using the product. Use the product strictly in accordance with the instructions.

Product Presentation

X13 blackhead suction instrument principle
The vacuum loop s formed through vacuu negative pressure, and the specially designed four-corner runway shaped suction head acts directly on the skin’and can keep the ultramicro bubble contact with the skin for a long time, promote. peeling effect, ulizamicro bubble and adsorption phase combined, in a safe and painless state, can deeply clean the face, remove aging keratinocytes, remove. sebum, thoroughly Remove all kinds of impurites, mites and grease residue from the har folicte funnel, and fll the hair follice funnel with combined, in a safe and painless state, can deeply clean the face, remove aging Keratinocytes, remove sebum, thoroughly Remove all kinds of impuriies, mites, and grease residue from the hair follicle funnel, and il the hair folite funnel with nutrients.

Product Parameter

skincare solution please know the skin
type of solution before use.)
Product efficacy| Cleans skin deeply and removes blackheads/ pimples Whitehead, makeup and oflremoval,
hydrating and moisturizing

Different Levels of Facial Massage

| Small s-shaped Suction Head: Normal suction, suitablefor cycle cleaning andmaintenance of T zone.
---|---
| Big 5-shaped Suction Head: Strong suction, sutablefor large area cleaning
| Cross-shaped suction Head:
Medium suction, sultablefor large area adsorption
| Small 5-shaped Softglue Suction Head: Normal suction, suitablefor cyclic cleaning andmaintenance of Sensitiveskin T zone.
| Wediun s-shaped Sotglue Sucton Head: Medium suction, sutablefor cyclic cleaning and maintenance of sensitive skin
| 8ig 5-shaped Softglue Suction Head: Strong suction, sultablefor large area cleaning

Usage

1. It is recommended that ater cleansing with warm water, apply a hot towel o your nose for 2-3 minutes to open the pores.
2. Add about two-thirds of the water in the clear water tank, do not ‘exceed the highest red water level, and willthe tank i installed vertically back into the fuselage.
3. Select different suction heads and nstall them on the machine as required. Long press the machine switch button to open the machine and select appropriate gear strength. Ltis recommended to use the small ound hole suction head first, and operate according to the correct use method. When the machine stops Lt is recommended not to exceed 2 Seconds, and each use time should not be too long. When using, the suction head cannot b left n the same place for long time parts, need to keep siding and lfting. (Remember ot to stay in the same area for a ong time.)
4. Slide and lft distance of 1-2 cm each fime,
5. Watermarks can be found on the parts after liding away.
6. After using ths product, It is a normal reaction to appear redness on the face. (fthe redness does not disappear after half an hour, please use 2 hot towel 10 apply heat to the reddened area)
7. Integrated water tank: no need to change the water frequently it can be used for a long time and improve your experience

Warning

1. After using this product,please store it in a dry place, do not store tin a place with direct sunlight or heat source;
2. Chldren must be used, cleaned, and maintained under the supenvision and guidance of the guardian;
3. D0 ot charge in a humid environment;
4. This appliance should not be played with by children.
5. When charging the product, please be sure to turn off the power and connect the charging cable for charging
6. Please wipe the water or other iquid on the machine before use, 5o as to avoid water or other liquid entering the machine and damaging the machine;
7. This product should not be used in plastic surgery, thinoplasty, and other parts of cosmetic sk surgery;
8. This product s not waterproof,please do not wash it with water to avoid damage;
9. If the power cord is damaged, it must be replaced with a professional cord or special component bought from its manufacturer or maintenance department;
10. Non-professionals are not allowed to disassemble, repair, refit, or replace the buit-in battery by themselves, 5o as to avoid dang
11. D0 not put the product nto fire or water to avoid short circuits or other unpredictable dangers:
12. Do not knock or drop the product. If the product s damaged due to collsion or drop, please stop immediately Use and contact our company after-sales.

Cleaning and maintenance

• Need maintenance, please make sure the power is off first.· Please do not wash the machine with clean water, which may damage the machine. Please use a dry cloth or soft cloth with a little soap wipe.
• Clean the suction head: when cleaning the suction head, please remove the suction head and rinse it with clean water.
• Do not use corrosive solution to wipe the fuselage: do not use alcohol, thinner, gasoline, nail remover, wipe, may cause product failure or parts cracking, discoloration, etc

Storage

Water Tank disassembly method

1. Pick up the machine vertically 90°, hold the body with one hand and the water tank with the other hand, turn the water tank out of the alignment slot and pull it down. Gently pull out the tank and add the right amount of water to the clean tank.

Water Tank installation method

1. Pick up the machine at a vertical angle of 90°, hold the body with one hand and the water tank with the other hand, with the screen of the body facing you, and gently press the water tank nto the machine. f the water tank cannot be pressed into the machine, you can turn t to the alignment groove until the water tank is pressed into the body (the body has a buckle, please do not force the water tank into the machine, so as not to damage the body or the water tank)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>