Yebicola HR-F3 Astronaut Nebula Projector User Guide
- June 15, 2024
- Yebicola
Table of Contents
Yebicola HR-F3 Astronaut Nebula Projector
Attention
- The light source of stars and nebulae is strong,so eyes should not look directly at the light source.
- The head and body of the astronaut are connected together by magnets,and the direction of the head can be adjusted. Do not stretch the astronaut’s head and body forcefully, otherwise the wires may break due to stretching.
The projection direction can be adjusted by adjusting the rotation angle of the astronaut’s head
Product key function
-
NEBULA
After booting, each time you press the button, Nebula will switch to a color, and return to the default color after a cycle. Long press the button to turn off the Nebula, and short press the button after closing the Nebula to turn it back on. -
ON/OFF
Short press to turn on, and Nebula and Stars are turned on by default after turning on; after turning on, long press the button again to turn off. -
start
Each time you press it to switch a star mode, long press the button to turn off the star, and short press the button after turning off the star to turn it back on. -
ON/OFF: ON/OFF
-
Nebula brightness+: The default brightness is mid-range, and each time you press it, the brightness increases by one level.
-
Nebula brightness-: The default brightness is mid-range, and each time you press it, the brightness decreases by one.
-
Nebula change speed-: Each time you press, the speed of the nebula will decrease by one level until it stops
-
Nebula change speed+: The change speed of the nebula increases by one level each time you press it, until the fastest
-
Nebula color switching: Each time you press the button, the Nebula switches to a color, and after a cycle, it returns to the default color. Long-press the button to turn off the Nebula, and short-press the button after closing the Nebula to turn it back on.
-
Star mode switch: The breathing of the stars changes-the stars are always (Cyclic single press)
-
Star brightness -: The brightness of the stars cannot be adjusted in the state of breathing changes, and the brightness of the stars is adjustable in the state of constant light; the default brightness is the brightest, and the brightness is reduced by one level each time vou press it.
-
Star brightness+: Each time you press the star, the brightness of the star increases by one level
-
Star breathing rate -: Star breathing rate is divided into four gears 0-1-2-3. Gear O means no breathing, gear 3 is the fastest breathing rate, and the default gear is gear 2. Each time you press the star, the breathing speed decreases by one gear until 0 gear.
-
Star breathing rat+: Each time you press the star, the breathing speed increases by one level
-
Reset: Click to return to the boot mode
Product parameters
Important security information
- Do not disassemble the product under any circumstances. There are no repairable parts inside the product
- Make sure your local power outlet matches the voltage required for your device (USB DC SV/lA)
- Do not operate this product when the power cord has been worn or broken
- This product should be kept away from heat sources, such as radiators, heat registers, stoves or other electrical appliances that generate heat.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>