Schneider Electric NNZ58425 Wireless Devices Wi-Fi Antenna Owner’s Manual

June 15, 2024
Schneider Electric

Schneider Electric NNZ58425 Wireless Devices Wi-Fi Antenna Owner’s Manual
Schneider Electric NNZ58425 Wireless Devices Wi-Fi
Antenna

Retain instruction sheet for future use.
Visit our website at www.se.com

PLEASE NOTE

  • Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel.
  • All pertinent state, regional, and local safety regulations must be observed when installing and using this product.
  • No responsibility is assumed by Schneider Electric for any consequences arising out of the use of this material.

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH

  • Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E, CSA Z462, NOM-029-STPS or local equivalent.
  • This equipment must only be installed and serviced by qualified electrical personnel.
  • Turn off all power supplying this equipment before working on or inside equipment.
  • Always use a properly rated voltage sensing device to confirm power is off.
  • Replace all devices, doors, and covers before turning on power to this equipment.
  • Do not exceed the device’s ratings for maximum limits.
    Failure to follow these instructions will result in death or serious injury.

Required for Installation

Dimensions

Installation

NOTICE

HAZARD OF EQUIPMENT DAMAGE

  • For each bend in the antenna’s cable, the radius of curvature must be more than 100 mm (3.93 in.).
  • The cable must not be wound in a loop.
  • Remove the antenna from the roof for the transport of the equipment.
    Failure to follow these instructions can result in equipment damage.
    Installation

PAS800 / PAS800L / PAS800P

Installation

PAS600 / PAS600L / PAS600T

WARNING

HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH

  • Remove the roof before drilling to prevent shavings from falling into the equipment.
  • Install a 10 to 12 mm (0.39 to 0.47 in.) diameter cable gland to maintain IP31 protection.
    Failure to follow these instructions can result in death, serious injury, or equipment damage.
    Installation

Technical Characteristics

  • Dual Band Antenna: 2.4 GHz, 5 GHz
  • Kit Composition: Antenna with Cable 3 m
  • Input Impedance: 50 Ω
  • Connector Type: RPSMA male antenna gain 2-3 dBi
  • Net Weight: 150 g

Radio Frequency Compliance Statements

EU Declaration of Conformity
Hereby, Schneider Electric Industries SAS, declares that the Panel Server is in compliance with the essential requirements and other relevant provisions of RED Directive 2014/53/EU.
The EU declaration of conformity PS21060101(Advanced) and PS20042001(Universal) can be downloaded on www.se.com/docs

  • Operating frequency for Wi-Fi is 2.4 GHz and 5 GHz, for others is 2.4 GHz
  • Maximum radio-frequency power transmitted:
    • Wi-Fi: ≤ 100 mW
    • IEEE 802.15.4: ≤ 10 mW

United Kingdom

UK Declaration of Conformity
Hereby, Schneider Electric Industries SAS, declares that the Panel Server is in compliance with the essential requirements and other relevant provisions of RED Directive UK SI 2017 No. 1206.
The UK declaration of conformity UK_PS20042001 can be downloaded on www.se.com/docs.

  • Operating frequency for Wi-Fi is 2.4 GHz and 5 GHz, for others is 2.4 GHz
  • Maximum radio-frequency power transmitted:
    • Wi-Fi: ≤ 100 mW
    • IEEE 802.15.4: ≤ 10 mW0

Contents of Toxic or Hazardous Substances or Elements

Part Name| Toxic or hazardous Substances and Elements
PASA-ANTI
(Pb)| (Hg)| a(Cd)| (Cr’)| (PBB)| (PBDE)
Metal Parts| X| 0| 0| 0| 0| 0
Electronic Parts| X| 0| 0| 0| 0| 0
Plastic Parts| 0| 0| 0| 0| 0| 0
Contacts| 0| 0| 0| 0| 0| 0
Cables and cabling accessories| 0| 0| 0| 0| 0| 0

O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is below the limit requirement in SJ/T11363-2006.

X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used for this part is above the limit requirement in SJ/T11363-2006.

Note: The products on sale may or may not contain all the parts/components listed here.

Schneider Electric Industries SAS
35 rue Joseph Monier
CS 30323
F- 92506 Rueil Malmaison Cedex
www.se.com

Schneider Electric Limited
Stafford Park 5
Telford, TF3 3BL
United Kingdom
www.se.com/uk

Schneider Electric logo

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Schneider Electric User Manuals

Related Manuals