Trust ZPIR-8000 Motion Sensor User Manual

June 4, 2024
Trust

PREMIUM-LINE
Item 71170 Version 1.0
Always read the instructions
before using this product
ZPIR-8000 Motion Sensor
User Manual

ZPIR-8000 Motion Sensor

Trust ZPIR-8000 Motion Sensor - fig

www.trust.com/zigbeeTrust ZPIR-8000 Motion
Sensor - fig 1

COMPATIBILITY

The sensor works with the Z1 ZigBee Bridge and the ICS-2000/Smart Bridge.

(RE)PLACE THE BATTERIES

**A**Remove the battery cover from the sensor.
**B**Place 2x AAA batteries (not included) in the sensor. Note the positive and negative polarity in the compartment. Close the battery cover.

INDICATORS

The sensor contains a LED indicator (This is not a button) to show the status of the sensor. Please see below the meaning of the different LED indications.

LED FUNCTION TABLE

Connection mode| LED will flash once per second for approximately 1 min. (After 1 min the

LED will stop flashing)

---|---
Connected successfully| LED will stop flashing (The App will also indicate when the connection is successful)
Sensor reset| LED will flash fast (for 2 seconds)
Sensor triggered (When motion is detected)| LED will flash once

 DOWNLOAD APP

To connect the sensor with a Z1 ZigBee bridge or ICS-2000/Smart Bridge, first, get the App by scanning the QR code or go to trust.com/ Zigbee and install it.

CONNECT SENSOR

**A**In the App, select a room, press the button, and follow instructions. For manual setup of push notifications go to the rules tab, press the + button, and select notification wizard.

MOUNT THE SENSOR

**A** Mount the arm of the sensor on a flat surface and secure it with the included screws.
**B 1** Place the sensor on the mounting arm.
2 Secure the sensor by pulling it down on the mounting arm.

RESET SENSOR AND ACTIVATE CONNECT MODE
Warning: This step will remove the sensor from the Z1 ZigBee Bridge or the ICS-2000/Smart Bridge. To reset the sensor press the button in the hole at the side of the sensor for approximately 5 sec with the included pin. The LED will flash fast to confirm the reset.
Activate connect mode: After resetting the sensor you can activate the connect mode by pressing the button for approx. 1 sec. The LED will flash for 1 minute to indicate the
connection mode.
The wireless range increases when you add more ZigBee products (meshing). To learn more about meshing go to trust.com/zigbee

ww.trust.com/zigbee

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals