BRITA 511423.001 Large 10 Cup Water Filter Pitcher User Manual
- June 15, 2024
- BRITA
Table of Contents
BRITA 511423.001 Large 10 Cup Water Filter Pitcher User Manual
You’re just minutes away from better water without the waste.
-
Hand-wash pitcher, lid and reservoir. With clean hands, flush filter with cold water for 15 seconds. Rinse well.
Do not wash in dishwasher.
Do not use abrasive cleaners. -
Remove lid and insert filter below line to seal.
-
Press firmly to ensure the filter is secure.
-
Turn lid over to access filter indicator reset panel. For this Brita® Standard filter (white), push the button below the white filter. Hold for at least 5 seconds to start.
NOTE: Light will flash 3X to confirm.
For systems with calendar sticker, see separate instruction card -
Once set, the light on top of the lid will pulse every time you pour:
Green – Filter life sufficient
Yellow – You’ve filtered 35 gallons (132 L), replace filter soon
Red – You’ve filtered 40 gallons (151 L), time to change filter Visit brita.com for more details.
Canada: Visit brita.ca.
-
Fill the reservoir with cold tap water to max-fill line. Pour out first 3 fills of water or use to water plants.
Hot water shouldn’t be used with the Brita® Standard filter (Max. 85°F/29°C – Min. 32°F/0°C).
PERFORMANCE
-
For more information, including certified contaminant reduction claims, Performance Data Sheet and warranty information, please visit brita.com/performance-data or call 1-800-24-BRITA.
Canada: Visit brita.com/performance-data or call 1-800-387-6940. -
You may need to change your filter more or less often than 2 months/40 gallons (151 L), depending on the amount and quality of the water you consume. For water with high levels of sediment, sand and/or rust, the Brita® Standard filter may need to be changed more frequently to maintain the flow rate.
-
We recommend that you keep your Brita® system out of direct sunlight and replace any filtered water that’s been left sitting for several days or more.
-
For best results when filling pitcher reservoir, pour tap water on the side of the reservoir rather than directly on top of the filter.
-
The filter change indicator measures water usage by counting the number of reservoir fills.
The indicator measures water usage when the lid is opened for 5–8 seconds. Always fill to max fill line to ensure accuracy and close the lid after each reservoir fill. -
Pitcher works with all Brita® system filters except Stream.
Visit : brita.com/performance-data
to find the full list of contaminants reduced, sign up for filter reminders,
earn points, claim rewards and more!†
- No bottles to throw away.
† Points and rewards available to U.S. residents only.
Canada: Visit brita.ca to sign up for filter reminders.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>