TRIO 224210102 LED Wall Ceiling Lamp Instruction Manual
- June 15, 2024
- Trio
Table of Contents
TRIO 224210102 LED Wall Ceiling Lamp
SAFETY NOTES
The product may not be disposed of with household waste. Always take the product to a collection point for the recycling of electrical and electronic equipment at the end of its service life. Please enquire about this point at your responsible municipal administration. The same also applies to any batteries or rechargeable batteries that may be included in the scope of delivery. Any removable batteries or rechargeable batteries must be removed before being taken to a collection point. Dealers are obliged to take back the old appliance free of charge. Old appliances often contain sensitive personal data. For your own sake, please note that each end user is responsible for deleting the data on the old appliances to be disposed of.
MAINTENANCE
Only clean the lumiere when it is switched off and cooled. The maintenance of luminaires is limited to the surface. In this case, no moisture should enter the area around the connections or live parts. For cleaning, use a soft moistened cloth with a mild detergent. Allow the luminaire to dry completely before cleaning.
USING FOR THE FIRST TIME
In general, through mechanical or thermal loads, lumieres can cause injury. In order to minimise the risk of injury, ensure that floor lamps and table lamps are secure and mount wall luminaires out of the reach of children.
Do not operate the luminaire if the luminaire itself (or its power cable) has visible damage.
Electrical connections should only be carried out by specialist staff. The installation instructions should be followed in accordance with the national rules concerning the fitting of appliances.
In order to avoid hazards, a damaged external flexible cable should only be exchanged by a specialist technician.
The requirements of the installation site concerning the IP safety class of the lumiere must be followed.
In general, do not mount luminaires on a moist or conductive substrate.
Warning! Before starting the installation work, ensure that the mains lead is not carrying current (de-energised).
Designation of the connection terminals L = Phase, N = Neutral lead, = Earthing conductor.
When installing, ensure that the leads are not damaged.
If silicone piping is enclosed with the lumiere, the piping must be put over the mains lead in order to protect against heat.
All safety and and design glassware fitted on the lumiere must be applied in perfect condition. Otherwise, the lumiere should not be operated.
Warning! The luminaire will be hot in the area around the bulb. Do not exchange the bulb when the device is switched on.
The stated maximum wattage of each individual lighting unit should not be exceeded. When replacing the bulb, please observe the stated maximum values on the lighting units or in the instruction manual.
Before using the lumiere for the first time, make sure the bulb sits securely in the holder.
The quartz glass of the halogen bulb should not be touched with bare hands (this does not apply to cold light reflector bulbs with a front glass). If this happens though inadvertently, the quartz glass should be wiped with alcohol before switching the bulb on.
| The lumiere is suitable for indoor use.
---|---
| The lumiere is suitable for outdoor use.
| Safety class I:
In order to guarantee the safety of the luminaire, this lumiere must be
connected to the earth lead terminal with the earth lead.
| Safety class II:
There is no opportunity to connect the safety lead. The safety of the
luminaire is guaranteed using special insulation measures.
| Safety class III:
The luminaire is designed for an extra low voltage and/or a low voltage.
| Warning! Risk of an electric shock. Light source coverings should not
be opened as conductive parts will be exposed.
| In order to avoid overheating, the minimum distance to the illuminated
surface or combustible materials (in metres) should be observed.
| As a spare bulb, only use bulbs which do not have ‚cool beam‘ qualities (no
cold light reflector bulbs). The use of these cold light reflector bulbs can
lead to the bulbs and/or the fastening surface becoming overheated.
| Safety class IP20 …
IP65 describes protection against the penetration of dust, foreign bodies and
water. In general, our luminaires are designed for safety class IP20. These
are suitable for use in living rooms. For installation in wet rooms or
outdoors, different requirements may apply. In connection with this, observe
the national installation guidelines. If the luminaire has a safety class that
differs from IP20, you can find this information in the luminaire‘s operating
instructions and the rating plate.
| Operation only with dimmable LED illuminants
| Lightsource not replaceable
| Lightsource replaceable by professional
| Lightsource replaceable by end user
| Control gear not replaceable
| Control gear replaceable by professional
| Control gear replaceable by end user.
| Trailing edge phase dimmer
| Leading edge phase dimmer
| Universal dimmer
| The luminaire is suitable for mounting on walls and ceilings
| This luminaire is only suitable for mounting on ceilings.
| This luminaire is only suitable for mounting on walls.
| This luminaire is not suitable for operating on external dimmers
| This luminaire is suitable for operating on external dimmers.
| This light is not dimmable.
Customer Support
TRIO Leuchten GmbH
TRIO International GmbH
Gut Nierhof 17
D-59757 Arnsberg
www.trio-lighting.com
TRIO Lighting Italia s. r. l.
Via Padre Giuseppe Masciadri 2H
22066 Mariano Comense
www.trio-lighting.com
TRIO Lighting Ibèrica S.L.
C/ Can Lletget n°9 nave9
Pol. Ind. Can Roqueta
08206 Sabadell
www.trio-lighting.com
WEEE-Reg. Nr.: DE78273666
TRIO Lighting Ibérica s.l.: RAEE 4544
TRIO Lighting Italia s.r.l.: RAEE IT13020000007829
TRIO Lighting Scandinavia Oy: WEEE PIR2005Y354114/2114
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>