Ocean Loong 2000W Eco Ceramic Heater and Bladeless Tower Fan and HEPA Air Purifier Instruction Manual
- June 15, 2024
- Ocean Loong
Table of Contents
- Ocean Loong 2000W Eco Ceramic Heater and Bladeless Tower Fan and HEPA Air
- Operating Instruction
- Introduction of Product fittings
- Assembly Instructions
- Principle of air outlet
- Direction adjustment
- Clearing blockage
- Matters needing attention
- IMPORTANT SAFETY INSTRUCTIONS
- IMPORTANT SAFETY FEATURES
- Documents / Resources
Ocean Loong 2000W Eco Ceramic Heater and Bladeless Tower Fan and HEPA Air
Purifier
Ocean loong
Bladeless Purifier & Heater Fan
Operating Instruction
Thank you very much for using our products, please kindly read through the manual before Use
Introduction of Product fittings
-
Adjustable Tilt Direction
-
Output Channel
-
Outlet Circle
-
Main Body
-
Input Channel
-
80° Head Swinging Devicea
-
Base
Remote control & Touch screen button instructions- Voltage: 230V
- Rating frequency: 50/60Hz
- Power Rating:
- Cool: 28W
- Hot: 2000W
- Sway angle: 80°
- Tilt-Head: 270°
-
Power
-
Fan speed –
-
Heater/fan switch over
-
Timer –
-
Sway
-
Heater +
-
Fan speed +
-
Heater –
-
Max Speed
-
Timer +
-
Wind speed +
-
Wind speed –
-
Timer
Assembly Instructions
- Aim the base at the body preparing to install.
- Push the body to the base and rotate the body to left unit it clicks into the base.
Replacing the H13 HEPA Filter
- Pull off the H13 HEPA net part.
- Replace the new HEPA.
- Assemble the net back.
Cool Mode
- Press directly into cool mode
- Press + or – into ajdust wind power
Heater Mode
- Press button then press button, hot/cool mode.
- And press to chanqe back to thenatural wind mode.
- Ceramic Heater with adjustable Thermostat. You can set the temperature from 16°C to 37°C.
- When the temperature reaches the setted degrees,it will automatically stand by and automatically turn on the warm air mode
Principle of air outlet
Our Bladeless Purifier and Heater Fan different with traditional fan, It through air cut produce natura wind natural wind is by the base with motor pulls in air, and the inlet air is pushed to the top blow ring effectively cooling the air, the high pressure air flows through the designed shape and high speed pushes input air.
Principle of Hot wind
When airflow go through PTC heating unit,airflow to get heating effect,
thereby release hot wind.
Direction adjustment
Caution: Don’t push the outlet down to this section!
- According to the angle, you need to adjust the outlet. 270 degree adjusted.
Clearing blockage
Ensure the heater is unplugged and has been allowed to cool.Look for blockages is the air inlet holes and in the small aperture inside the air loop amplifier. Use a soft brush to remove debris.
Cleaning
Unplug from the mains electricity supply. Allow to cool for 1 to 2 hours
before cleaning if the heater has been in use. To clean, wipe with a dry or
damp cloth. Do not use detergents or polishes.
Matters needing attention
This heater is hot when in use and for a short period after use.Do not let bare skin touch hot surfaces. If children are present, consider positioning the heater out of their reach.
Replace Battery
Tear down the battery hatchcover, take out of used battery, then put the new
battery instead of make battery bin is loaded in the positive & negative
direction and close battery cover .
IMPORTANT SAFETY INSTRUCTIONS
BEFORE USING THIS APPLIANCE READ ALL INSTRUCTIONS AND CAUTIONARY MARKINGS IN THIS MANUAL AND ON THE APPLIANCE.
When using an electrical appliance, basic precautions should always be followed including the following:
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
-
This heater is hot when in use and for a short period after use. To avoid burns, do not let bare skin touch hot surfaces. When moving the heater hold it by the base, not the air loop amplifier.
-
Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains ,at least 0.9m (3 feet) from the front of the heater and keep them away from the sides and rear when the heater is plugged in
-
Extreme caution is necessary when any heater is used by or near children or infirm persons and whenever the heater is left operating and unattended.
-
Do not allow to be used as a toy. Close attention is necessary when used by or near young children, Children should be supervised to ensure that they do not play with the heater or remote control.
-
This heater and remote control are not intended for use by young children or infirm persons with reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge, unless they hove been given supervision or instruction by a responsible person concerning use of the heater to ensure that they can use it safely.
-
The base must be fitted securely before operating. Do not dismantle or use without the base fitted.
-
Suitable for dry locations ONLY. Do not use outdoors or on wet surfaces. Do not use in bathrooms, laundry areas and similar indoor locations.
Never locate the heater where it may fall into a bath or other water container. Do not use or store where it may get wet or in the immediate surroundings of a bath, a shower, or a swimming pool. -
A heater has hot parts inside. Do not use it in areas where petrol, paint, or flammable liquids are used or stared or where their vapours are present. Do not use in conjunction with or directly next to an air freshener or similar products.
-
Do not locate directly below a mains electricity supply socket.
-
Always plug directly into a wall socket. Never use with an extension cable as overloading may result in the cable overheating and catching fire.
-
Do not handle any part of the plug or heater with wet hands.
-
Do not unplug by pulling on the cable. To unplug, grasp the plug, not the cable.
-
Do not stretch the cable or place the cable under strain. Do not run the cable under carpeting. Do not cover the cable with throw rugs, runners, or similar coverings. Do not route the cable under furniture or appliances. To avoid o tripping hazard arrange the cable away from traffic areas so that it will not be tripped over.
-
Do not use with a damaged cable or plug. If the supply cable is damaged it must be replaced by this company or its service agent or similarly qualified persons in order to avoid a hazard.
-
To disconnect the heater, turn the controls off, then remove the plug from the socket. Always unplug the heater when not in use.
-
Do not use if the heater malfunctions or has been dropped or damaged in any manner. Contact the this company Helpline or return to an authorised service facility for examination and/or repair.
-
To prevent a possible fire, do not use with any opening or exhaust blocked, and keep free of dust, lint, hair, and anything that may reduce airflow. Do not put any object into the inlet grill or the exhaust opening as this may cause an electric shock or fire, or damage the heater.
-
Do not use on soft surfaces, such as a bed, where openings may become blocked.
-
Use only as described in this Operating Manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
-
In order to avoid overheating and fire hazard, do not cover the heater.
-
Choking hazard: the remote control unit contains a small battery. Keep the remote control away from children and do not swallow the battery.
If the battery is swallowed seek medical advice at once -
The heater should be positioned so the airflow is directed away from any walls or room corners.
IMPORTANT SAFETY FEATURES
For your safety this heater is fitted with automatic cut-out switches that operate if the heater tips over or overheats. If the switches operate, unplug the heater and allow it to cool. Before restarting the heater check and clear any blockages and ensure the heater is on a solid level surface
READ AND SAVE THESE INSTRUCTIONS THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE ONLY
Reminder
If the instructions do not conform to the product, please refer to the actual
operation.
All righes of interpretation of this product belong to Dongguan Anzheluo
Electrical Appliance Co., Ltd.
Name and content description of harmful sufstances in products
Part name
| Toxi and harmful substances or elements
---|---
(Pb)| (Hg)|
(cd)
| Cr(VJ))| {PBB)| (PBDE:)
ResistorComponent| 0| 0| 0| 0| 0| 0
CapacitorCompo1ent| X| 0| 0| 0| 0| 0
High voltage capacitor| X| 0| 0| 0| 0| 0
Circuit
Circtit Bo.rd
| 0
0
| 0
0
| 0
0
| 0
0
| X
0
| X
0
LED Disclav| X| 0| 0| 0| 0| 0
Solder| X| 0| 0| 0| 0| 0
Intern.Iwiring| X| 0| 0| 0| 0| 0
Te1111inals| 0| 0| 0| X| 0| 0
Plasticme| 0| 0| 0| 0| 0| 0
Spray paint| 0| 0| 0| 0| 0| 0
Power co·d| X| 0| 0| 0| 0| 0
Sc•e1•1| 0| 0| 0| X| 0| 0
fuse| X| 0| 0| 0| 0| 0
rempar,turecomrolswitch| 0| 0| 0| X| 0| 0
PTC heating wire| 0| 0| 0| 0| 0| 0
Main motor| 0| X| 0| 0| 0| 0
Swingl’e;.dsynchrcnousmotcr| 0| 0| 0| 0| 0| 0
qemolecontrol| 0| X| 0| 0| 0| 0
label s:ic k er| 0| 0| 0| 0| 0| 0
T his form is compiled in accordance with
SJ/11364.
0: Indicatesthat the content of the toxic and harmful substance in all homogeneous materials of the component is below the limit specified in GB/T26572.
X: Indicates that the content of the toxic and harmful sub s tance i n at l east one
homogeneous material of the pa r t exceeds the limit s./;_ecified in GBT26572.
Note: Some of the parts marked ·x· above contain harm ul substances which exceed the standard due to the l imitation of current i ndustry technology l e vel, and it is
difficult to achieve substitution or reduction for the time being. –
- This product meets the requirements of the «Regulations on the Restriction of the Use of Hazardous Substances in Electrical and Electronic Products»
- During the period of environmental protection use ,consumers will not have harmful substance leakage and precipitation during normal use, which will affect consumers’ health. We can rest assured that
- The environmental protection service life of our products will be 10years.Only when this product is used under the normal conditions described in this specification can the” environmental protection service life” be effective.
Name and content identification of toxic and harmful substances or elements
Ocean Loong Bladeless Purifier and Heater Fan are exempt from insurance for
one year.
Terms and Conditions of One-year Warranty for your Bladeless Purifier and
Heater.
The warranty clause shall come into force as of the date of purchase.
All warranty work will be performed by Ocean Loong OR its authorized agent.
Any replacement parts will be owned by Ocean Loong.
Under the warranty terms, repairment and replacement services cannot extend
the warranty period.
Please keep your purchase notes.
Before repairing your products, please provide your purchase notes. We will
charge without this note.
Scope covered
Scope: within one year after purchase, defects due to poor materials,
workmanship or functions need to be repaired and maintained (if there are no
parts or production interruption, they will be replaced with practical parts)
Warranty card
Documents / Resources
|
Ocean Loong 2000W Eco Ceramic Heater and Bladeless Tower Fan and HEPA Air
Purifier
[pdf] Instruction Manual
2000W Eco Ceramic Heater and Bladeless Tower Fan and HEPA Air Purifier, 2000W,
Eco Ceramic Heater and Bladeless Tower Fan and HEPA Air Purifier, Bladeless
Tower Fan and HEPA Air Purifier, HEPA Air Purifier, Air Purifier
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>