Eco Net Control EVC300 Bulldog Controller User Guide
- June 15, 2024
- Eco Net Control
Table of Contents
Eco Net Control EVC300 Bulldog Controller
CONTROLLER
Basic Controller Functions
- Press to open or close Bulldog Motor.
- Press to reset the leak alarm.
- Press to pair leak sensors, emergency stop buttons, and remote buttons.
Controller LEDs
LED above – Current System State
- (Green): System is armed and ready. The valve is open.
- (Red): System is armed and ready. The valve is closed.
- (Green, Red): The valve Motor is not fully closed, not fully open, or the Valve Motor control wire is not connected.
- (Green, Blue, Red): Your Bulldog Controller has detected a leak and shut off your water.
NOTE: Your water shutoff valve cannot be opened until the leak alarm is reset.
Bulldog EVC300 Controller QuickStart Guide
LED next to – Current Valve Controller Command
- (Red): Valve is set to open.
- (No Colour): Valve is set to close.
Bulldog EVC300 Controller QuickStart Guide
LED above – Wi-Fi Status
- (Solid Blue): Your Bulldog Controller is connected to Wi-Fi.
- (Blinking Blue): Your Bulldog Motor is closed.
NOTE: To connect your controller to Wi-Fi, please see your EVC300 Wi-Fi Connectivity Guide.
Device pairing
NOTE: All devices included with your Starter Kit have already been paired with your Bulldog Controller.
Pairing Leak Sensors
- Press the button.
- Place a leak sensor on a wet paper towel and allow it to go through 2-3 beep cycles.
- Once the Leak Sensor or Emergency Stop button is paired, your Bulldog controller will enter an alert state.
- Clear the leak alert by pressing the Button.
- Click the button to re-open your water shutoff valve.
Pairing Optional Remote Button or Emergency Stop Button
- Press the button.
- Press and hold the Remote button.
Unpairing Devices
- All paired devices can be removed by pressing and holding the button for 5 seconds until the red LED blinks.
MAINTENANCE
- Maintenance should be performed every 6 months to ensure your device is armed and in working order.
Check Leak Sensor Battery
NOTE: Testing a Leak Sensors will trigger a leak alert.
- Set your leak sensor on a wet paper towel.
- Listen for the number of beeps.
- (2 beeps): Battery is charged.
- (3 beeps): Battery is low and needs to be replaced.
- (No beeps): The battery is dead, or the leak sensor is not properly being triggered.
- (Beeps but no leak alert): Leak Sensor is unpaired or non-functional.
- (Refer to section: Pairing Leak Sensors & Optional Emergency Stop Button)
Replace the Leak Sensor Battery
- Twist the leak sensor lid counterclockwise and lift.
- Replace the battery with Type A23 12 Volt only.
- Line up alignment marks. Close and lock with a clockwise twist.
Check Bulldog Functionality
- Close your bulldog water valve using the button.
- Turn on the water at the highest point in the building and observe the water flow after 10 seconds.
- (Water stops): Bulldog fully closes the valve.
- (Water continues running): Remove the Bulldog from the water shutoff and follow the Bulldog Mounting Instructions card included with the box.
- Open your bulldog water valve using the button.
SUPPORT
- Econet Support Email: support@econetcontrols.com.
- Econet Support Phone: 888-320-9188
- Leak Sensor Range Support Link: https://www.econetshop.com/PDF/SensorRange.pdf.
- Additional Support Page Link: https://www.econetshop.com/index.php/support/.
- Leak Sensor Pairing Video Link: https://www.youtube.com/watch?v=otzdhZbWBp4&t=146s.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>