Blokker 4108787-98bd79cc Tint Film Sun Protection Car Film User Guide

STICKING FILM ON CAR WINDOWS

What you need:

1. Glass cleaner or ethanol to clean the windows.
2. Plant spray filled with water and 5/10 drops of washing-up liquid.
3. Towel.
4. Rake.
5. Razor blade.
6. Window scraper.

Please note. For the first 6 steps do NOT remove the protective sheet.

1. Clean the windows thoroughly. Remove all impurities with a window scraper.
2. Spray the detergent solution on the outside of the window.
3. Cut the film to size: Place the film on the sprayed window with the sticky side towards you. (You can check this by loosening a small corner and feeling what the sticky side is).
4. Cut the shape of the window into the film.
5. Attention! A heat-gun and squeegee are necessary for curved windows, such as the rear window. This is in order to remove wrinkles.
6. Heat from the point where the wrinkles start and iron from the middle to the top. And from middle to bottom. Never iron from left to right.
7. Wet the inside of the window to be coated with the detergent solution.
8. Remove the protective sheet (when removing the protective sheet, leave the vinyl on the outside of the window).
9. Moisten the inside of the window to be coated with the detergent solution.
10. Then stick the window foil with the sticky side against the window and rub the water between the adhesive layer and the pane with the felt side of the squeegee.
11. After installing the film, please wait 48 hours before cleaning the film (greasy fingers) and turning down the side window.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>