iPE Official P670-4 Exhaust System Instruction Manual
- June 4, 2024
- iPE Official
Table of Contents
iPE Official P670-4 Exhaust System
Installation Manual
[Remote Controller System]
- Red Cable: Key on Switch
- Brown Cable: GND
- Yello Cable: TPS Voltage Signal 0~5V
- Electronic Valve
Step1. FIND FUSE BOX, CONNECT WITH RED POWER CORD IN ORDER, HANG THE GND AND THROTTLE VALVE SIGNAL 0-5V
-
FIND FUSE BOX UNDER THE GLOVE COMPARTMENT AT PASSENGER’S SEAT AND CONNECT RED POWER CORD ON THE NUBER “10” (THE SECOND-LAST)
↓SEE THE IMAGE BELOW -
HANG GND ABOVE THE FUSE BOX
-
FIND YELLOW/BLACK CABLE LINES FROM THE ELECTRONIC POWER CONTROL ON THE RIGHT-HAND SIDE OF THE ACCELERATOR PEDAL, THEN CONNECT YELLOW/BLACK CABLES
Step2. OPEN THE ENGINE BAY YOU WILL FIND THE SOLENOID VALVE ON YOUR RIGHT-HAND SIDE, PULL OUT THE “IN” AND “OUT ” CABLE LINE
Before
After Installation
CONNECT THE STOCK “IN” AND “OUT “SOLENOID VALVE TOGETHER WITH CABLE LINES. SEE THE IMAGE ON YOUR LEFT-HAND SIDE.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>