EVERGEAR DL-3312 12 Inch Dual Row LED Road Position Light Instruction Manual

EVERGEAR DL-3312 12 Inch Dual Row LED Road Position Light

PRODUCT ACCESSORIES

PARTS LIST

NO.| Description| Qty
1| Side Brackets| 2
2| Two holes connect the flat washer| 2
3| cp8 lock washer| 6
4| M816mm inner hexagon bolt| 4
5| M825mm hexagon bolt| 4
6| cp8 flat washer| 2
7| M8 nut| 4
8| Bracket Pad| 2
9| Middle Brackets| 2
10| Shockproof pad| 2
11| nylon tampon M8| 4
12| Light|

INSTALLING THE LIGHT

• SIDE BRACKETS INSTALLATION INSTRUCTIONS
  • 1. Side Brackets
  • 2. Two holes connect flat washer
  • 3. 98 lock washer
  • 4. M8*16mm inner hexagon bolt
  • 5. M8*25mm hexagon bolt
  • 6. 98 flat washer
  • 7. M8 nut
  • 11 .Graphite nylon pad
• MIDDLE BRACKETS\ INSTALLATION INSTRUCTIONS
  • 3. 98 lock washer
  • 5. M8*25mm hexagon bolt
  • 6. 98 flat washer
  • 7. M8 nut
  • 8. Bracket Pad
  • 9. Middle Brackets
  • 10. Shockproof pad

WIRING INSTRUCTIONS

WARNING

• This light is not DOT-approved and is for off-road use only. Check local traffic laws regarding restrictions on the use of off-road lights.
• It is recommended to have assistance while installing to prevent damage to the product or your vehicle.
• To prevent damage to this product, be sure that all equipment operates properly before beginning installation.
• Carefully plan and determine where to mount and wire equipment.
• Check to see that the light bar and mounting hardware fit the vehicle. Universal brackets may not fit the vehicle perfectly.
• Only use mounting equipment and hardware supplied with this product.
• Using non-factory equipment or modifying the mounting equipment may result in damage to the product.
• Use the specified voltage DC 9-60V.
• LEDs get very hot during operations. Allow at least 30 minutes for components to cool before touching the casing.
• Keep heat sink fins clean and free of debris to maintain adequate airflow.
• Do not stare directly into LED lighting within proximity and/or for extended periods as permanent damage to your eyesight may occur.
• Do not install this product in an area that will block and/or interfere with the operator’s driving ability.
• After installation, test all equipment to make sure it functions properly.
• Disturbance of the front bumper by drilling or other means could cause damage to an airbag sensor or cause an airbag to inflate in the vehicle. Check locations before installation.
• EVERGEAR assumes no liability whatsoever for any portion of an airbag restraint system during installation of this product.
• Likewise, we assume no liability whatsoever for any damages or expenses incurred or caused by the inflation of an airbag device during the installation of this product.
• Do not mount the light in a location where its surface could come in contact with the dashboard, grills, or other plastic parts on the front end of the vehicle.

PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>