LiFE 221-0017 3 In 1 65W Stand Fan User Manual

: June 15, 2024
: LIFE

Table of Contents

LiFE 221-0017 3 In 1 65W Stand Fan
SAFETY INSTRUCTIONS
PARTS IDENTIFICATION
UNPACKING THE APPLIANCE
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
PRODUCT FICHE
contact
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LiFE 221-0017 3 In 1 65W Stand Fan

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS.

Read the operating instructions carefully before putting the appliance into operation and keep the instructions, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions.

USER MANUAL SYMBOLS

Important information for your safety is specially marked. It is essential to comply with these instructions in order to avoid accidents and prevent damage to the machine:
WARNING : This sign warns you of dangers to your health and indicates possible injury risks.
CAUTION: This sign refers to possible hazards to the machine or other objects.
NOTE: This sign highlights tips and information

SAFETY INSTRUCTIONS

This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
Children should not play with the appliance.
Cleaning and maintenance of the device must not be done by children without supervision.
Use the fan only for purposes described in the instruction manual.
The appliance is intended exclusively for private, domestic use and for the intended purpose. This appliance is not suitable for professional use.
Do not use the appliance outdoors.
Always use on dry, level surface.
Before using the fan, make sure that the voltage in your mains is the same as that indicated on the label of the device.
Make sure the power cord is easily accessible at all times.
Keep the appliance away from heat sources, direct sunlight, moisture (never immerse it in any liquid), and sharp edges.
Do not operate the appliance without supervision. If you leave the room, you should always turn off the appliance. Remove the plug from the power supply.
The protective grills are to prevent direct access to moving parts when the fan is in use Avoid contact with any moving parts.
CAUTION : To avoid injury, do not insert your fingers between the grilles when the appliance is plugged in or when it is turned on.
CAUTION: Do not place clothes or other objects on the fan.
CAUTION : Do not use the appliance near curtains.
Periodically check the appliance and its cable for any damage.
WARNING: Do not use the appliance if it has been damaged in any way or if there are any visible signs of damage to the appliance. To avoid possible danger, do not attempt to repair the device yourself. Contact a qualified technician for repair. Use only original spare parts.
Do not attempt to repair the appliance yourself. Always contact an authorized technician.
WARNING: Use only original spare parts. The use of accessories not recommended or sold by the manufacturer of the device may cause hazards.
Do not use the appliance if its surface is cracked.
Do not operate any appliance, with a damaged cord plug after the appliance malfunctions, or has been dropped damaged in any manner.
If the power cord is damaged, it must be replaced by the manufacturer its service agent, or a similarly qualified person in order to avoid a hazard.
Do not use the appliance unless all its parts are fully assembled.
Do not place the power cord under the carpet.
Do not use or store the appliance in places where there are flammable materials and gases, or in an environment with a lot of dust, air, or steam.
Do not use the appliance near an open flame or other heating device.
Do not move the appliance during operation.
To disconnect from the electrical supply, grip the plug and pull from the wall outlet. DO NOT pull on the cord.
CAUTION: Keep the appliance away from children and pets.
Children should be supervised to ensure that they do not play with the appliance. In order to ensure your children’s safety, please keep all packaging (plastic bags, boxes, polystyrene, etc.) out of their reach.
CAUTION: Do not allow small children to play with the foil. There is a danger of suffocation!

PARTS IDENTIFICATION

STAND FAN

Front grill
Blade
Rear grill
Motor
Switch
Stand
Base cover
Screw
Stand base

FLOOR FAN

Front grill
Blade
Rear grill
Motor
Switch
Floor and wall base

WALL FAN

LiFE-221-0017-3 -In-1-65W-Stand-Fan-fig-3

Front grill
Blade
Rear grill
Motor
Switch
Floor and wall base
Hook

UNPACKING THE APPLIANCE

Remove the appliance from its packaging.
Remove all of the packaging material such as foils, filling material, cable holders, and cardboard packaging.
Check all the contents of the package.
Check the appliance for any damage to prevent a hazard.
NOTE: There may still be dust or production residues on the surface of the appliance. We recommend that you quickly wipe off the housing with a damp cloth.

ASSEMBLY INSTRUCTIONS

WARNING: The appliance should be completely assembled before initial operation!

STAND FAN

Place the upright support shaft into the recess in the base and secure the shaft by tightening the screws and nuts on the bottom of the base. Then install the base cover by passing the shaft through the hole in the cover.
When you have finished joining the stand base to the support shaft, place the device on a flat surface.
Then secure the motor onto the shaft by inserting the mounting screw . CAUTION : Make sure the motor is properly secured in place and is not in danger of coming out of place during use.
Place the back of the protective mesh on the front of the motor and align it with the corresponding holes on the motor. Then insert the screws and tighten them until the protective mesh locks into place.
Install the impeller onto the motor shaft. Align the mounting hole in the fan impeller with the notch (flat part) on the motor shaft, and secure it with the mounting screw.
CAUTION: Make sure the impeller is tight before proceeding to the next step.
Open the locking clips of the front protective mesh and unscrew the screw. Then align the hole of the front and rear-guard mesh and screw the screw to complete the joint and secure it. Close the locking clips to complete the assembly of the fan guard.

FLOOR FAN

The base of the floor fan consists of three parts. Join the three parts and secure them with the screws provided.
Then secure the motor onto the shaft by inserting the mounting screw.
CAUTION : Make sure the motor is properly secured in place and is not in danger of coming out of place during use.

WALL FAN

Assemble the base as with the floor fan.
Then slightly loosen the screw of the connection point of the base with the motor.
Rotate the floor and wall mount so that it rests parallel to the wall and is flush. Retighten the screw and nut on the joint.
Place the hook where you want on the wall using the eyelets and screws, then hang the fan base on the hook.

OPERATING INSTRUCTIONS

Set the stand fan on a dry and level surface.
Before connecting the appliance, make sure that the power supply of your appliance corresponds exactly to the voltage of your electrical installation.
Adjust speed by selecting one of three speeds (1-2-3), by turning the power switch. Indications 0-1-2-3 define the fan off or speed low/ medium/ high.
Set the fan accordingly to be stationary or rotate by pulling up or pushing down the knob on the back of the fan.
Turn the switch to position OFF to switch the appliance off.

CLEANING

Always disconnect the fan from the power supply before cleaning or assembling.
Do not immerse or pour water directly onto the appliance. Risk of electric shock and fire!
Do not allow water to drip on or into the fan motor housing.
Use a soft cloth dampened with a mild soap solution to clean it.
Do not use hard, abrasive or corrosive detergents or solvents to clean the appliance or any of the following as a cleaner: benzene, thinners or benzene.
To clean the fan blades, disconnect the front from the rear guard by opening the clips around the perimeter of the rear guard and unscrewing the locking screw. Use a soft damp cloth to clean the blades, then join the two protective grids and secure them by closing all clips and screwing in the locking screw

CAUTION: Make sure the fan is fully assembled before using the fan again.

STORAGE

Your fan can be stored partially disassembled or reassembled.

Always disconnect the appliance from the power supply before storing the device.
Make sure the appliance is cold and dry before storage.
Always store the appliance away from children.
Always store the appliance in a safe and clean place. For the best protection of the appliance, store it in its original packaging.
CAUTION: Make sure the fan is fully assembled before using the fan again.

DISPOSAL OF APPLIANCE AND ACCESSORIES

T his symbol appearing on the product, its accessories or accompanying manuals indicates – that the product and its electronic accessories should not be disposed of with other household trash. In order to avoid possible harmful effects on the environment or health due to uncontrolled waste disposal, please separate these products from other types of waste and recycle them. Household users should contact either the store where they purchased this product or their local services for details of where and how they can return these products for environmentally safe recycling.

PRODUCT FICHE

Information to identify the model(sl to which the information relates to

Information for model LIFE GRECALE

DESCRIPTION| SYMBOL| VALUE| UN IT
Maximum fan flow rate| F| 49| m3/sec
Fan power input| p| 63.9| w
Service Value| sv| 0.77| (m3/sec)W
Standby power consumption| Pss| I| w
Fan sound power level| lwA| 58.0| dB(a)
Maximum air velocity| C| 5.75| meters/sec
Nominal fan power input (PF), kW| 0.0639
Annual electricity consumption (Q), kWh/a| 20.45
Measurement standard for service value| IEC60879:2019 IEC60879: 1986 (corr.