HETP 78 LED Solar Interaction Wall Lamp Instruction Manual
- June 15, 2024
- HETP
Table of Contents
HETP 78 LED Solar Interaction Wall Lamp
Precautions
- During the first use of the product, place the product in a place with sufficient sunlight for charging, the product should be used after being charged for several hours.
- When the product will not be used for a long time, please place the product in a place with sufficient sunlight, too, the charging time is 1 day. To keep the function of the battery, you’d better comprehensively charge the product in a place with sufficient sunlight once a month.
- The charging time and charging efficiency of the solar panel may be affected by the weather and the installation position. Considering the conversion rate of solar power generation, if the product is used in good weather, it will gain higher charging efficiency and effectiveness.
- When there’s sunlight and other lights, and if the power switch is off, the LED lamp will not be lightened in day and night.
- The solar lamp should be installed in a place with sufficient light to ensure the solar panel will absorb sunlight sufficiently so that the working hours of the solar lamp will be prolonged.
- The angle of the solar lamp and the direction of the light should d be adjusted to the best position, it is suggested that the best height is 2-3m.
- During winter or when the sunshine duration is short, it is suggested to use the solar lamp under mode I.
Specification
- Name of product: Solar interaction wall lamp
- Model: ZJ-SL78
- Output: 5.5V, 2W
- Battery capacity: 2000mAh
- Angle of the sensor: 120 degrees
- Induction distance: 3-5 meters
- Brightness: 14001m
- Quantity of LED: 78LED
Use method
- For charging the built-in battery, please set the lamp in a place with direct sunlight
- The strong sunlight can be converted into solar energy more effectively.
- “Used in the place where the light is required, such as a path, garage backyard, etc. Within those areas, please place the light in a place that can be easily illuminated by the sunlight.
Used in the place where the light is required, such as a path, garage
backyard, etc. Within those areas, please place the light in a place that can
be easily illuminated by the sunlight.
Long press for Is to enter mode 1: Human body induction mode (the lamp
will be on when people come, and the lamp will be off after the people have
left for 15)
Pattern 2: Human body interaction + slight light mode (the lamp will be
on when people come, the lamp will be slight after the people have left for
155, and the lamp will be on again when people come)
Pattern 3: Slight light mode (the lamp be slightly lit all the time no
matter whether there’s any person or not)
Using method
Notes: If there’s sunlight or other lights on the solar panel, the lamp will not be on even if the ON/OFF switch has been turned on. During testing, another objective should be used to cover the solar panel, then the lamp will be on after turning on the ON/OFF switch.
- fix the device in a fit place with the equipped screws.
it is recommended to install it vertically against the wall 2-3m high above the ground as the picture shows you can try other ways to install it depending on the actual condition. but do not keep the solar panel upside down in any way, otherwise it will affect the effect of solar charging at daylight
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>